20 Most Recent Swimline Hydrotools Sand Filter - Page 9 Questions & Answers

filter clogging / dirty

check with the manufacturer

we had the E1 error on our mspa after a water change. solution was a reset for us. plug in power, briefly press test and wait 10 seconds. unplug the power and wait for 10 seconds. plug in the power again and wait 10 seconds after which the reset button is pressed. then press the temperature button on the controller and briefly switch the air button on and off. after this the thermostat did it again. we were relieved that this worked, we had already searched the whole internet. this solution was copied from a model of lay-z

Hi I have an Mspa Camaro P-CA090/069 I had an E1 Error code which I have sorted I believe it was the filter, but I'm finding the tub is struggling to heat up it was 26.5 and after 24 hrs it's only 28.5 I would be very grateful if someone can help me with this problem. Thanks

if cord is faulty replace it

Moved category from Cars and Trucks to Pool and SpaContact Haywood direct. It sounds like an erratic delivery of gas, or faulty ignition. Contact details on the warranty page.https://www.hayward-pool.com/assets/documents/pools/pdf/manuals/H-series-H100ID1-ABG1001.pdf..

plumbing supply --online search

is the gfi popping or unit just shuts off --notify customer service and ask about problem or sending it back for a new one if defective

That impeller is obsolete. It is woodruff keyed to that shaft, IF it is not plastic you can use a jaw set of gear pullers. If it is plastic you many need a bearing puller and a gear puller.

Send it back.

get scumball and let them float in pool

yes have to use the solar heat aux

clean salt sensor if ok bad sensor

over middle burner if ok check for cob web in burner orfice

bad seals in wet end to motor replace seals or whole pump

I don't have any information on the Laars S2 heater. However, the gas pressure requirements are usually consistent for all appliances. The manual for the Laars Mighty Therm 2, MTP2. gives the maximum (3.2 kPa) and minimum (1.2 kPa) incoming gas pressure on page 13. The manual is available here: https://www.laars.com/images/uploads/products/1211J-NH.pdf . I hope this helps. Cindy Wells

Erratic operation is to be expected in a unit that is 25 years old.

Did you find a manual, I am after the same one..

...on then goes to service and shows 56 Bo means bypass operation which means the heater is being controlled by an outside control.

hayward pool heater service code Questions & Answers (with ...

https://www.fixya.com > Forum > Tags and also https://www.troublefreepool.com/threads/hayward-h150fdn-heater-error-code-56-or-sb-and-resetting-itself.213240/ Make model manual. Should give you trouble codes although they seem to use Letter codes. https://www.hayward-pool.com/assets/documents/pools/pdf/manuals/UniversalH-seriesLowNOx-HxxxFDOwners.pdf ..