20 Most Recent Hoover WindTunnel TSeries Bagless Upright Vacuum Cleaner UH70107 - Page 4 Questions & Answers

Probably belt burning due to a roller jam. Take a look.

pump inoperative or feed tubes clogged. need to check the small belt; not the main belt.

That would make it 'spot less' wouldn't it? :>D It seems to be a known issue with a struck trigger. Take a look at the videos. https://www.google.com/search?q=hoover+spotless+upholstery+cleaner+won%27t+spray+water ..

The sensor is dirty. The next time you change the bag, leave it off and the cover as well. Plug the sweeper in and turn it on for a few seconds. The lights should blink then run steady. This is the best way to blow out dust. It should be done outside.

Hi Karen Parts Schematic and Parts List with Parts Numbers in this link https://www.partswarehouse.com/FH50220-Hoover-Steamvac-Max-Extract-6-Floor-Cleaner-s/3384.htm and others. Often you can find a better quality image. Also click on the ALL tab. https://www.google.com/search?q=hoover+fh50220+parts+schematic&rlz=1C1QJDB_enCA643CA644&sxsrf=AOaemvKOQCFW1KpEk26nSxsrQ1gaO3vAEQ:1640563036077&tbm=isch&source=iu&ictx=1&fir=QWs2P3LJ5S3hsM%252CxtE5s-ZTiSuRGM%252C_%253BPV7FXg_FUo2kSM%252CcDUDfNqu_pxWeM%252C_%253B8_8XKITlYUAAcM%252CpO7b34dTVGOtAM%252C_%253BQhDemHHV0Ks89M%252CpiQZyJNb2ZH0JM%252C_%253BhyUiYueGT80MDM%252CpO7b34dTVGOtAM%252C_%253Bz5kEu0gOSsXI6M%252CO_jJsnDnms8ZYM%252C_%253BHfIdH7ignCUlaM%252CvXicS480SgXlAM%252C_%253BahbSsB98towQVM%252CB8JJFg4ujNrNIM%252C_%253BMPsKmYbmITmcvM%252CbBNaujdN50DnpM%252C_%253BymREvVvIsAlkGM%252C-gcJSFVoqj0NGM%252C_&vet=1&usg=AI4_-kRRYW_fJp4EhIMj-J8KoBWtvTuh8g&sa=X&ved=2ahUKEwjRrvzH1YL1AhUbCM0KHVnZDB8Q9QF6BAghEAE ..

There are some disassembly videos here, but basically you undo screws until you get to it. Lay everything out in the order it came apart and take pictures. https://www.google.com/search?q=How+do+I+replace+a+Hoover+wind+tunnel+height+lever ..

https://www.repairclinic.com/ProductDetail/933621

Question edited to add FULL Make Model (what it is) Question moved from Microwaves category to Hoover Vacuum. Looks like 2015-2016 https://www.google.com/search?q=U8185-900+review ..

Does it have a belt drive and is it broken or need cleaning out

There is a break in the wire probably around the handle or plug. Turn the vacuum cleaner on and shake the cord. If the vacuum cleaner shuts on and off, replace the cord.

I am not sure about your particular model. But I had a small cheapy Hoover Upright that would not turn on. I pulled it apart (lots of screws) and found the inline fuse blew. I was able to fine a inline car fuse and install it and it worked fine.

It doesn't have a belt. The brushrolls are turned by a gearbox.

Might need a new belt

It might be clogged somewhere. A lot of the machines brought in to my shop for repairs actually were not squirting out enough water to have enough to suck up. It was only enough to get the carpet damp making the owner think it wasn't sucking up water. Make sure it is putting out enough water.

The pedal or part of the body where the pedal catches at are probably broken or worn

This parts schematic shows the filters https://www.partswarehouse.com/Hoover-S3755-s/1047.htm Page 7 of the manual tells you how to clean it. https://www.manualslib.com/manual/280289/Hoover-S3755.html?page=7 ..

DRY SEALS LEAK

The compartment where the bag goes inside will be a place to put you thumb and push down. Now slide the door forward. The front panel will drop forward. It is hinged from the bottom.

Have the same issue. Ever find out why??