20 Most Recent Miller Trailblazer 302 Welder Generator 907217 907216 - Page 6 Questions & Answers

Call a electrician unplug it turn off the breaker turn off the switch www.apparelstore38.com

If you need the manual, then I have a couple of sites that could help. ManualsLib Makes it easy to find manuals online Free User Manuals and Owners Guides ManualsOnline com

$100

http://www.manualsonline.com/ This may help you

ESAB Fabricator 141i Multi Process Welding System (W1003141) NEW is only $650 Go NEW! Warranty, New unit will work for several years. Best bet!

the same thing happened with my 280 nt . I've just spent almost a grand on pc board . when i picked it up from roberts oxygen it worked . when i got it home , no weld output again. motor and generator works great though, but that's not why i had a welding machine. i believe something is grounding it out , and possibly blowing the pc board . . anyone want to buy it ?

Sounds like a fuel problem to me. It starves for fuel and the governor speeds it up and then it runs out of fuel and stops. Check fuel filter and pump. The line to the pump may be partially stopped up. Robert

The wire feed drive circuit board has a short circuit scr or other component. You will probable need to get a new board. Robert

Do you have a carburetor on this unit? If so this is your problem, a sticky or bad needle valve can cause your problem, along with a bad float adjustment. Good Luck Friend.

First thing I would check is a good ground. This is very important. Your ground should always be to clean metal. Metal that is being welded should also be clean. Good Luck Friend.

check for a circuit from the machine , through the trigger back to the relay that runs the rollers

The relay/contactor seems to be stuck. It is the thing with moving contacts and a coil. It is in the circuit as the power comes into the unit.

if you welded to long and overheated when cools down will reset ----if on and were not welding then check and test thermal protector for failure

This machine is an auto adjust for different voltages. The front end of the circuity is a PMPS or pulse mode power supply. No matter the input, the output is the same. Most all small appliances today are built around this technology. I bet a small IC on the circuit board has gone bad. A good electronics repair man could fix this or you can get the board from Miller.

Holy tards talk about having no clue the guy asked about a melted switch for polarity not about all this other bunk. Ok so first off on front that ain’t a switch it’s just a dial indicator that points to either positive or negative polarity , unscrew the knob then unscrew the four nuts turn the bridge 90 degrees and reinstall the nuts and screw the indicator back in

it is already 220VAC there is no 220 volt 3 phase.

connect the + lead to the spool gun so that there is power at the end of the wire to make the arc there should have been a user manual showing how to connect it into the system try searching -- user manual for ( make and model of ) spool gun

Have a 130 xp welds the same with or with out the gas welds not smooth

I think your on /off switch is the problem. Depending on age of unit and amount of usage this is the first thing I would check . You can check switch with a multi meter to see if it says in the closed position and if it stays in the closed position , causing your unit to stay on. Good Luck Friend.

What is the question?