20 Most Recent
Questions & Answers
It stops after 1hour and 40 minutes of running how
A treadmill will shut down from to much friction which is due to high motor current because the walkbelt and deck are not properly lubricated. I would recommend applying .5 oz of lubricant on the deck every 3-6 months or 100 hours of use. This will extend your treadmill's life many years.
on Jan 16, 2016
How do i unhook the electrical connection from the
You must watch the flexible cable or connector from display board vs Lower
Board or Main Motor Controller.
Then you must isolate the Main Motor Controller from Power Supply coming from coil or Transformer. +Pull out the fuse and turn Off.
See the block diagram that I did as people like you for yourself take carefully.
Finally to make short circuit in Boar or component. sincerely.
on Nov 29, 2011
NordicTrack speeding up for no reason
This make all this adjustments:
Make sure the sensor speed is as close as possible to the pulley withouttouching it. You will see a magneton the face of the pulley; make sure the sensor is aligned with themagnet. There is a screw thatholds the sensor in place that needs to be loosened to adjust thesensor. Re-tighten the screw whenfinished.
Good luck, sincerely.
on Nov 29, 2011
Hi! We have a
Welcome to FixYa!
Check if the latch knob is facing the correct direction
. It should be facing inwards
, not outwards.
The upper barrel should insert through
the latch knob and lower barrel if the latch knob is placed in the correct direction. Please refer to the image below.
Note that assembling the storage latch is crucial. It can damage the latch knob if installed incorrectly.
I hope this will help.
Thank you for using FixYa and have a great workout!
on Mar 14, 2011
Not finding what you are looking for?