20 Most Recent
Toshiba 1360 Black and White Copier - Page 3 Questions & Answers
E-studio 16S showing CA1
CA1 indicates the polygon motor abnormality in laser unit.
Well, u can take out the laser unit by removing the paper tray, toner, power supply and u will see the
laser unit.
Normally, if no connectors issue, then then only choice u have is to replace the laser unit.
Trying to clean: corona wires, mirrors & upper fuser roller
Dear sir; I try my best to descript for you, corona wire have two, one we call charge corona wire it located above the drum,when you open the door you will see the toner cartridge on the bottom left corner of the toner ctg you will find a 1" squar blue plastic push up and pull out. the another one we call discharge corona wire, it located right under the drum unit, open the door lift up the **** shellon the bottom middle with a red plastic head, you have to remove waste toner bottle and then you can see a screw loose it ,lift up and remove the unit,you can use Q-tip withrubbing alcohol to clean it, hope you can find it. need help? I always here,
Good luck, let me know if you made it, thank you.
HAVE A HAPPY HOLIDAY !!!
Black streaks appearing on copies
Well there is not to many things thst would cause that problem,try cleaning the corona wires ,all the mirrors,and check the upper fuser roller.
Toshiba 1360 copier
Turn it on holding down 0 and 8. Key in 89, press start. press 0, press start. Turn it off and on.
Toshiba 1360 C7 Error Code
TOSHIBA
1310
C7
Fusing unit warm-up error, defective thermistor, fusing lamp or thermofuse
The codes are good for several models.
Toshiba 1360
Did you replace the cleanerblade?
Power off the machine, switch on while pressing 0 & 8, enter 200, then press the start button, the machine will run for about three minutes to adjust the Toner sensor. The machine will stop, press the interupt button to save the setting, switch off and then on.
If the older techies is reading this, please help to confirm.
Default setting
Your machine is old analague and a few years old now.It should be no problem changing.If your exposure settings are out it may be drum wear but more often or not all mirrors needing good clean.
Off top of head....M/c off..hold down 0and 8 numerics and power on...AD or AJ on display.punch in 15 and press print..... should read 00 on display... punch in01 and press green print button..press 09 and m/c ready to go if not switch off and on.
If unhappy with auto expose or manual middle expose...0+5 power on...AD or AJ on display,punch in 0+1 then print key opens exposure....pressing 1 increases light each press,,,try poss.10 times and print after to load.. and 7 decreases light to darken then print to change value. 0+9 together will get m/c to ready please try, all the best.
Toshiba 3160 copier
Would you say that the bottom half is Ghosting? if so then the fuser hot roller teflon has worn and will need replacing.
If not please check the optical mirrors (Do not remove them only remove the top glass) for dust.
Sorry cannot be anymore help as you may possibly need a engineer call out.
Thanks J
ERROR C7
TOSHIBA
1210
C7
Fusing unit warm-up error, defective thermistor, fusing lamp or thermofuse
Not finding what you are looking for?