20 Most Recent Behringer Europower Pmp5000 Powered Mixer Pmp5000 - Page 9 Questions & Answers

Specify the full fuse ratings please. Internal fuses come in all shapes and sizes.

Read the manuals for both the mixer and the active speakers. If you do not have the manuals, download them from the manufacturers websites. If you don't know hw to use equipment, don't buy it.

Hi, the power light should not "blink" at any point. It should always be either on or off when either powered on or off. Sounds as though the internal toroidal transformer has gone faulty (common issue) and requires replacemnet by a professional.

Clean the sockets and switches with a good contact cleaner.

my peavy does that to me when I use a cheap extension cord,it has to be heavy duty cord,or plugged directly into receptical

http://www.gitarrenfundgrube.de/manual/Behringer-GMX110_GMX112_GMX1200H_GMX210_GMX212_M_EN.pdf Below is a link to Guitar Center which appears to have this instrument. Guitar Center Music Instruments Accessories and Equipment

It sounds like a n overheating problem. Some component is running too hot and shutting down. This will not be a user servicable problem and it needs to go into the shop. Discuss it with the shop when you take it in to be sure they will have access to the parts they need. Behringer is notoriously slow to ship parts so if it's an exclusively Behringer part as compared to a general electronic part you may have to consider replacing the unit depending on what time frame you have to work with.

There has to be some internal problem for a fuse to blow. Putting in a bigger fuse can only cause more problems.

Pray. Maybe the God is playing it.

Try www.elektrotanya.com - you can down load 2 manuals per day, else pass the electronics test to get more :-)

Looking at pictures on line, you'll nee to remove the electronics panel - take out the screws around the rear edge at the back & the 3 at the top, behind the handle / in front of the panel. I would expect the panel to come out thru' the rear..... Be aware of the speaker lead - could be a bit short so you may need to disconnect it. Once the electronics panel (mixer & amp etx) is clear you should be able to get your hand inside / under the handle & undo the bolts. There's a possibility the if the handle is held on with bolts then there could be "blind" or "Tee" nuts under, so undoing the handle screws may be all you need to do? Take care though, because if they're normal nuts they could drop off into the gubbins! Good Luck!

In my opinion, due to the physical appearance of pmp4000 and pmp3000 look the same, it will most likely also have a common circuit and parts list (at least, most). Usually Behringer (and all the manufacturers), with the same series / sequence, using the same circuit, the difference is the number of channels only. You can compare the parts list on PMP3000 schematic, with your PMP4000. PMP4000. PMP3000 You can download from this link. http://elektrotanya.com/behringer_pmp3000_sch.rar/download.html Hope this helps. Regards.

It's probably not cost effective to repair it' Check the horn driver and the raw woofer to see if they are still good, and if so retain then as spares.

It's always possible, but I doubt it's the fader. I'd suggest taking it to the shop for a hands on diagnosis.

i suggest you contact Behringer Customer Service for advixce. Without the setup in front of me, it's hard to figure out the wire routeing, switch positions, ect. that may be leading to this problem. As they would be the people most familiar with the gear, they'sd be the people to ask. http://www.music-group.com/support/behringer/askquestion

You can connect where it is possible. I hope you will understand.

On what channels from what source? Is it from USB too? have you got the gains set right? are you overdriving the amp? does the USB output distort as well?