20 Most Recent Honda 2500 PSI Gas Pressure Washer - Page 6 Questions & Answers

There shoud be a bolt on either side of starter you be sure to label wires before removing the starter

Web search "pressure washer unloader valve". Sometimes simply removing/installing the valve will get it working.

look at sight glass on pump

If its not the carburetors (fuel from), then its fuel flow into the carburetors. Disconnect fuel line at some common point into the carburetors and check flow volume.

Check into the store that sells Honda's mowers or where you bought that mower. Sometimes you can find what your needing at garage sales or on the Internet for used decks.

cracked housing or bad gasket or seal

rpms are too low at full throttle

there's no diagram. If your drive cable is kinked it wont release properly and cause this issue. also if the adj arm pivot bushings are worn it will **** sideways and cause this issue

take it to a dealer

honda.com

if reverse order of taking off the old one

what about it?

pin is sheared