20 Most Recent
Husky Husqvarna Chain Saw 240E w 16in bar - Page 3 Questions & Answers
My husky 460 rancher needs a new chain sprocket, how do I remove the clutch assy to get to it?
There is a special tool that fits into the clutch with a 19mm head on it so as to fit an impact wrench part no. 502541601, however you can remove it using a suitable screw driver, preferably the one that came with the saw, insert into one of the slots provided in the clutch, now use a hammer and keep striking the head of the screw driver to jar the clutch off against the compression of the saw ( keep deco valve out ) remember its a left hand thread so clockwise , it will eventually spin off
5/20/2018 9:20:37 PM •
Husky Garden
•
Answered
on May 20, 2018
I have a husky 61 that I think was made in 1981 how would I take the carburetor off?
Not too difficult, remove the top cover, 3 screws, remove the air filter, 2 screws on the later filter, 1 single screw on the early filter, remove the fuel hose and blank off with a suitable bung, gently pry the choke out of the choke shaft ( this is a bayonet style fit ) remove the throttle wire by pring it up and out of the throttle lever,now use a 4mm allen key to remove the two carb securing screws, you will need a short allen key to remove the lower l/h screw, the carb will now come away be carful not to lose the gasket, the induction block will also come away from the back of the cylinder. there will be another gasket here., all these components will have to be aligned to re fit the carb.
5/17/2018 8:57:57 PM •
Husky Garden
•
Answered
on May 17, 2018
Not finding what you are looking for?