20 Most Recent Stihl Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835 - Page 4 Questions & Answers

does it have a spark and good compression.?

over fueling could suggest worn carb diaphragm, or blocked air filter, meaning the fuel mixture isn't getting enough air. blocked fuel filters can also lead to poor acceleration.

I've added the TS410 brake down as they're all basically the same and you haven't stated the model to which you're referring. http://www.mediafire.com/download/dk8dipzr69pksrk

http://www.mediafire.com/download/dk8dipzr69pksrk I've added the breakdown manual for you, have you replaced the fuel and air filters. could be a simple issue of not being able to draw up the fuel from the tank. Stone saws deal with a lot of dust and this seriously effects their running and also their cooling capabilities.

make and model please.

Sounds like a faulty fuel tank vent, creating a vacuum lock. Replace the vent

From nowhere. All of it a paid downloads. no need to try more. http://electronicshelponline.blogspot.com/

You may get a compression lock of some kind on these engines sometimes (2 stroke and 4 stroke) and I have had this happen a couple of times when trying to start them thinking that the mechanism had seized up when it had not. You pull the cord and it locks solid. You cannot turn the engine over. I have always managed to eventually free it though. What I would do in your case is remove the spark plug and then see if you can pull the starter cord.

F First you need a plunger stopper or take a extra long sparkplug plug which can serve as a plunger stopper. And you can the parts thats centrifugal disc unscrew normally counterclockwise

The vent nipple in the tank is not good open? can also but a thermic problem in the ignition coil is also possible , It is not the first time I do this along with a brand new saw. Go quickly change the saw if, within eight days of purchase entitles you to sit there and not forget your receipt

poss carb problem change carb

on the side you will see 3 holes one with a h and one with a l on the letter with a L screw it in fully then un screw one and a half turns on the letter that says H screw fully in then unscrew it back four turns

stop switch damage

poss magnito

poss draging in air, or carb problem

First clean or replace the air filter. If the fuel in the tank is more than 2 months old dump it out and put in fresh fuel. Clean or replace the spark plug.

if this machine ran ok before this problem,and no one has adjusted the carb,then i would check the crank seals.i have just had this problem.and it was the seal on the puller side,though i replaced both whilst i was at it.hope this helps my freind.

Clean the air filter and check that the choke is operating correctly.