20 Most Recent
Polaroid Polaview 211E Multimedia Projector - Page 3 Questions & Answers
Cannot remember makers code for
Well the default PIN code for pairing your polaroid PoGo printer via Bluetooth is 6000.
Hope that helps. please let me know if you need further assistance
thanks for using fixya
I have old poloroid pictures
Yes! but first you must scan them into the computer and open them in a photo editor application like Photoshop. There you can do a whole world of editing including lightening your fotos.
Good luck and god bless!
Hello, I've been trying to
First perform systems connectivity inspection on the printer to the computer. Ascertain that the power cables are in source of current. Second, ascertain that the cable connection from the printer to the computer is intact. Third if any cables were loose, reconnection attempts would require restarting the computer altogether to acquire the new settings before printer actions can take place. Second perform a test print job. Usually the type of material requirign printing should have been highlighted or selected with the mouse as an indication of what requires hard copying. Clicking on the printer job buttons should achieve responses fo action. Important notes.
1. A change of printer accessories like ink or paper may have caused printer malfunction. Inspect the compartments that holds ink/ paper for inappropiately closed entrapments, dislodged supplies or depleted.
2. An attempt to expose the ink compartment while printer is still powered to the computer would require powerign of for restarting once more to acquire the new settings.
3.Refer to the printer user guide for details
How to change empty tray message please?
Question edited for typos.
All questions need full 'make model (what it is)' as the first 3 words.
Remove the tray and look for sensors or something on the paper tray that registers when it is out of paper. Fill the tray and replace it.
Also try a power reset. Remove to wall plug for 10 minutes then plug it back in.
..
Shredder Essentials SES-C1525 Shredder. How do I unjam a ses-c1525 jammed with what I think is sticky gunk.
Question edited for full 'make model (what it is)'.
People don't realize that shredders need oiling regularly. Spray all the blades and the gunk with WD40. Leave it half an hour and spray it again. Run it in reverse to clear the jam. If you have been using it a lot, they have a thermal cut out which should reset after about 20 minutes or so. Bad jams and heat, shatter and shred the gears inside the head. Is the motor making any noise?
Not finding what you are looking for?
