Russell Hobbs 13153 Iron - Answered Questions & Fixed issues
I have so far seen
I would write to russell hobbs and complain, my friend bought one of these 18 months ago and hers got hot but no steam through. She sent it back to them and they sent her a new one as a gesture of goodwill.
8/21/2011 5:34:24 PM •
Russell Hobbs...
•
Answered
on Aug 21, 2011
•
2,129 views
The iron heats up, but when the steam generator
Chemicals and minerals in the water have probably clogged the vents. Empty the water. Pour 1/2 cup WHITE vinegar into the reservoir. Turn on your iron and let it heat. Then press the steam generator button several times until the vinegar is gone. Unplug the iron. As it is cooling, take acotton swab and gently wipe the surface of the vents. You can probe GENTLY with the swab, but don't push it into the vent or the cotton head may get stuck.
As you're pressing the steam button, keep the iron in the ironing position, not standing. If the vinegar just will not come out of the vents, use a wooden toothpick to loosen the build up.
This always works well for me and I hope it does for you.
If so, please come back to Fixya and rate my advice!
7/21/2018 12:54:22 PM •
Russell Hobbs...
•
Answered
on Jul 21, 2018
•
2,760 views
Iron not heating
Hello
first try it in a different outlet
if the iron still does not get hot,you might need return it and get a different one
otherwise there isn't much you can do.
GOODLUCK
Brown water and seems like sand or fine grit comes
sounds like it is time to de-scale the iron to loosen all the deposits inside the unit.
add some white viegar to the water ( which should be distilled water ) and heat up and let the iron steam out the solution. now add just water to the unit shake it and rinse out with water and drain. now do one more vinegar / water de-scaling and rinse out again. now fill with just distilled water and let it steam out and now your iron should be clean as new.
c...
2/12/2011 9:11:35 AM •
Russell Hobbs...
•
Answered
on Feb 12, 2011
•
2,031 views
How to dismantle a russell hobbs steamglide iron
To disassemble the Russell Hobbs 15081 steam glide iron, you have to remove the two hidden screws on the handle. To locate the first screw remove the two adjacent blue buttons which are each held in with two hidden clips front and rear, so lever out with small screwdriver or similar. The second hidden screw is under the pivots of the water inlet lid.(I broke one of the plastic pivots but no big deal). Then using a thin blade, separate the top half of the handle from the bottom half of the handle. A bit of force is needed as there are more plastic clips. I started from the rear.
Once the top half the handle is removed, other screws become visible, so teardown is not hard, just note which screws go where, as they are different lengths.
My problem was that some of the screws/bolts were so corroded I needed to drill them out. The thermostat was also corroded, which probably explained why the thermal fuse had blown. The element was fine.
10/23/2021 5:55:05 PM •
Russell Hobbs...
•
Answered
on Oct 23, 2021
•
6,534 views
Not finding what you are looking for?