20 Most Recent
- Page 4 Questions & Answers
Is there actually any one
I have solved it at last! Remove the 5 screws on the bottom. There are 2 more screws (which may be blackened with oil) located through the grille directly below the motor. They're stumpy little things with gripping washers. I had to bend the plastic grille thingys to get screwdriver in. Once released, these will enable the whole base to be removed. Then there are 3 screws to get the plate off to put the new belt on. Put the belt around the big cog. Replace the 3 screws of the plate. The motor drive is loose now so you can angle the drive cog to attach the belt to this. Using gravity by turning the processor on it's edge you should with some fiddling be able to put the stumpy screws back in - took me a couple of goes. Replace the 5 screws and robert is a very close relative.
on Aug 31, 2013
Need manual for kenwood gourmet fp310
I have search the internet for the FP310 manual and cant find it anywhere. I dont suppose you know where I could get it from, would really appreciate a little help. Its like Kenwood have forgotten about my little processor!! : ( Ha!
Thanks in advance, AImee
on May 12, 2013
Hi my mixer suddenly wont
if its like mine the belt or pulley wear out mine took 8 years for it wear out. i couldnt find the parts so i took of the base(make sure its unplugged) remove the belt(hold one side of belt over the large cog and turn the cog, the belt should fall off) get a large rubber band (the width of the pulley)and twist the band over the pulley a number of times until it fits tightly over the pulley, replace belt and base and it should work.
this will work if the belt or pulley teeth are worn
my wife still cant beleive it worked
on Apr 16, 2013
I have Kenwood DS700 kitchen scales - they have
I just did it after a long research, keep the button pressed as the unit is switching on, it will display "hold for setting 3", "hold for setting 2", "hold for setting 1", and then it will display gms and oz, keep the button pressed till the desired unit is highlighted.
The key is not to vary the pressure on the button, else you will have to switch it off and start over again.
on Feb 26, 2013
Not finding what you are looking for?