20 Most Recent Linksys Cisco Small Business WAP4410N WirelessN Access Point PoEAdvanced Security (S7271261) - Page 9 Questions & Answers

Sir Using 3g wireless Linksys Routers is best router you use for inter net connection, For customers using the AT&T 3G MicroCell and a Linksys / Cisco router model WRT54G2 or equivalent, the following settings should be made to the router. NOTE: Changing the broadband router / modem / gateway settings may cause other applications to stop working, and / or change the broadband router security settings for outbound data transmissions. Please see the router / modem / gateway instruction manual for more detailed information. Procedure 1.Open Internet Explorer and navigate to the router setup page at http://192.168.1.1 2.Enter the User name and Password, click OK 3.Verify the following settings: Automatic Configuration - DHCP MTU: Auto Size: 1492 4.Select the Security tab, verify IPSec Pass through is set to Enable 5.Click Save Settings I Hope Your Router Linksys Routers Problem Is resolved By now: In case you need online Linksys Routers help then follow us on for: Linksys Router Support

no such product

Follow the easy to use instructions in the router user guide Linksys Support

FORGOTTEN MY ADMIN CODE AND PIN NO. FOR 0474878580 wI FI

Where do I find my SSID #?

CALL THE COMPANY OF THE MODEM OR THE PERSON OF YOUR ISP OR LOOK UP THE NAME OF THE BRAND ON THE INTERNET

CALL THE PEOPLE OF THE MODEM OR THE INTERNET SERVICE PROVIDER OR LOOK UP THE NAME OF THE MODEM ON THE INTERNET

Go to your asterisk CLI by typing: asterisk -r -vvvvv and check the messages that comes across. You may find a "NOTICE" stating failed to register and the reason why. My case was an ACL permission, which is the Deny or Permit section of the extensions config. Here is the default, which will allow anyone to register and is not recommended. Deny: 0.0.0.0/0.0.0.0 Permit:0.0.0.0/0.0.0.0

This is normally on your router page settings. Access your router's management page using your computer browser. Then under Access Restrictions tab, check category Website Blocking by URL Address Facebook shouldn't be in the list then save the settings.

It's possible that this is a hardware failure or a power adapter failure. Try to reset the unit and reinstall it again. You can also check for firmware updates available online. Try to use other power adapter as well with the same specs with the original power adapter.

Your router may be set to not respond to pings. Are you sure you have typed the correct address? From a command prompt (open start menu and run cmd.exe from the run box or search box, depending on operating system) and type ipconfig to see the gateway ip address, which is the address of your router.

If it is set to the default the username should be "admin" and the password should be either "admin" or "password". If they have been changed and you cannot access it, you will have to factory reset it by holding the reset button down for 10-15 seconds then access it using the credentils above.