20 Most Recent NetGear ReadyNAS Duo RND2150 NAS server (S6819023) Network Storage Server - Page 9 Questions & Answers

If the printer is connected via wireless it may not be set up correctly, as a network printer. Connect it up via a USB cable to make sure it works, then change it to Wireless configuration and re-install it as a network not a USB printer.

Replace it, it is obviously faulty.

Here is the manual http://www.downloads.netgear.com/files/DM111P(U)v2_UM_06Oct08.pdf

Page 64, you can block the internet site by keyword of "facebook" See manual http://www.downloads.netgear.com/files/FVG318_RM_09Oct07.pdf

It is not compatible with a netgear router because they do the same job, one on broadband and one on 3G HSPA. Two routers do not connect to each other.

The problem is towards the ISP connection. Contact the ISP with the problem.

The computer does not support WPS.

Try the label on the back of the router.

Is it connected via cable? If so disconnect the cable, if you want it to work wireless.

Try the label at the back of the router.

Look at the label at the back of the router.

Netgear does not require a country code!

Have a look at the back of the router.

Reset Microsoft Internet Explorer back to default settings to clear the problem. Pick tools (Alt +T), then settings then advanced Tab. At the bottom is the restore settings to default button. Press it. then Apply and OK to exist settings.

Yes, you need to use the correct SSID, ask the owner. Also you need to set up the correct protocol to use the password.

Check the "break in the connection with the modem". The failure is coming from outside the router, towards the ISP's connection.

It will be an Ethernet connection. So you should set up the control panel, networks to show icons of connected networks in the taskbar.

You need to purchase a wireless adaptor (USB 2.0) to make the connection with the wireless router. Look on Amazon or Ebay, there are lots to choose from

If you have an internet connection already, why do you need the netgear router? Error 10091 is "Provider entry RSVP TCP service provider could not perform simple loopback communication". It sounds as if you are setting up the router wrongly, consult your ISP.

You can only reset the DHCP lease, so it starts again. Or you can set a new timeout.