20 Most Recent Infinity BassLink II Car Subwoofer Questions & Answers


If the speaker has been overdriven, it may have damaged the cone surround or damaged the speaker coil, causing it to 'rub' inside the magnet. To check for rubbing, you need to move the speaker cone backwards and forwards by hand and listen where the speaker coil/cone goes into the magnet. It should be silent if ok. If you can heara rubbing or grating noise, then the speaker is damaged. If the output driver on the amp is damaged it can give a distorted sound, which could easily happen if it tries to provide too much current.

Infinity... | Answered on Nov 04, 2009


Fuse is blown because you may have bad DC to DC converter circuit (step up circuit from 12vdc to provide +-/- 30~40vdc) that supplys the power amp section. I can be that the output stage of the amp shorted out and it took out the DC to DC converter circuit.

Infinity... | Answered on Oct 31, 2009


does the back seat flip up

Infinity... | Answered on Jul 30, 2009


Tapping into front or rear gets high level signal 3 plus volts at low impedance which is totally unsuitable for the sub's line level input which is more like 300millivolts > A competent tech could make up an attenuator patch or just take it to a professional car installer before you do more damage
ataraxia

Infinity... | Answered on Mar 23, 2009


From what i have heard, If you have a speaker level input connection. this sympton does occur. You buy a scosche LOC and try giving the input to Basslink, it should work fine

Infinity... | Answered on Aug 18, 2008


There is a static that builds on the woofer , check the wiring and check grounding of the woofer once again

Infinity... | Answered on Apr 27, 2008


You have it wired to your accesories setting, you need to wire it to to your " Run " wire. Try this, Look in your fuse box and find the fuse that only has vultage when the car is on. Use a voltemeter. Then just wrap the wire around the fuse and insert it back in.

Your cars repair manual, If you picked one up, will have a wiring diagram in the back, where it shows the starting system, it will say weather the wire is "Hot" has voltage when the car is in the "on/RUN" position, or in the Accessories position. You want to plug it into the RUN wire so that its only on when the car is on and running, this way you dont drain your battery.

Make sur eyou have a fuseable link between in the positive wire thats connected to the battery so you dont fry your sub with to much voltage.

Infinity... | Answered on Feb 29, 2008


Definately a wiring issue. Go to this site and backtrack to see where you went wrong. hope it helps.

http://www.ehow.com/how_5829_wire-car-stereo.html

Infinity... | Answered on Feb 18, 2008


yes the problem is in the installation.the power supply usually has 2 to 3 positives one positive which is usually red go directly to battery. the other,either yellow,orange,or blue go to car stereo(not to battery or ignition) this supply,turn off the amp when u turn of the stereo. hope this help u....

Infinity... | Answered on May 09, 2007


Auto cut is due to overload, check out the wattage handling capacity of the Amp & the woofer( if the impedence is too low there will be an over load for the Amp.

Infinity... | Answered on May 06, 2007


FACTORY AMPLIFIER IS MADE TO DRIVE THE SPEAKER IN THE VEHICLE IF NO SOUND YOUR AMP NEED REPLACEMENT

Infinity Car... | Answered on Sep 12, 2019


hy I have a becker traffic pro high and I need cod.serial BE7825 model 35001465

Car Audio &... | Answered on Nov 02, 2018


hi,

if thats a dodge this might be it..

Re: Infinity Gold AMP Wire Diagram



Well I don't particularly care for Haynes manuals, but my FSM's did not have anything either. I found this in thejeep cherokee haynes manual and it says that it is for 97 and later models but see if it is close. it looks like there are 2 harnesses so I will list them seperately:

Hartness 1:
[7] Left Soundbar Speaker (+) BR/YL
[8] Left Soundbar Speaker (-) BR/LB
[5] Left Front Door Spkr (+) DG
[1] Left Front Door Spkr (-) BR/RD
[9] Right Soundbar Speaker (+) DB/WT
[3] Right Soundbar Speaker (-) DB/OR
[6] Right Front Door Spkr (+) VT
[2] Right Front Door Spkr (-) DB/RD
[4] Power Amp Relay Feed DG/RD

Harness 2:
[05] Right Soundbar Spkr (+) TN/RD
[13] Right Soundbar Spkr (-) TN/BK
[06] Left Soundbar Spkr (+) WT/TN
[14] Left Soundbar Spkr (-) WT/BK
[11] Passenger Door Spkr (+) LB/RD
[10] Passenger Door Spkr (-) LB/BK
[04] Drivers Door Spkr (+) DG
[12] Drivers Door Spkr (-) LG/RD
[01] Power Amp Feed
[02] Power Amp Feed
[07] Power Amp Ground
[08] Power Amp Ground

The tweeters run in parallel off of the door speakers.... If I can help any more let me know.

-Mike.
https://forums.off-road.com/jeep-mid-sized/105694-infinity-gold-amp-wire-diagram.html

Infinity Car... | Answered on Oct 01, 2018

Not finding what you are looking for?
Infinity BassLink II Car Subwoofer Logo

Popular Tags

15 questions posted

Ask a Question

Usually answered in minutes!

Top Infinity Car Audio & Video Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Ekse

Level 3 Expert

13434 Answers

Mark Skinner

Level 2 Expert

79 Answers

Are you an Infinity Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Infinity Car Audio & Video

  • Infinity Car Audio & Video

Most Popular Question

basslink worked great son blew fuse

  • Car Audio & Video
Loading...