20 Most Recent
Kirby Shampooer Shampoo Hose G3 Ultimate Diamond Vacuum - Page 8 Questions & Answers
Turn off the brake
If you remove the handle, you will notice there is one larger black Phillips screw under the black plastic strip.
Engage the wheels and loosen that screw.
Slide the lower handle part back and forth and you will notice the wheels will reverse and go forward again.
Find the position where the wheels lock and unlock for you, and tighten that one screw again.
It does not take very much adjustment to make that system engage so do it in small increments.
You will see what I mean when you unlock that screw and slide the lower handle just a tad , but the wheels must be in the engaged position in order to adjust it properly.
Hope this helps!
William R!
Should the green light be on while I am using my Kirby vaccum
If you mean the light on the top or side of the Power Nozzle, yes, it should be on for most uses. You can disengage the belt for other uses. The green light illuminates when the belt is turning the brush roll. So, you see, the green light functions to confirm to you that the brush roll is spinning. For carpet, you would want the brush roll spinning. When I vacuum my comforter or sofa, I don't have the belt engaged because I don't want the roller to grab up my fabric. For that use, the green light is not illuminated.
Kirby brush bar is not turning?
Turn off your vacuum and unplug. Look at the brushroll and belt, check if the belt is broken, stuck or stretched out. If the belt is fine, check the brushroll, is it worn out (barely any bristles left) and are the ends warped or melted. Also make sure there is no fibers or hairs wrapped around the brushroll, especially the ends.
GoodVac.com
www.goodvac.com
1-800-775-6586
Why does my kirby shake ?
If your Kirby is just sitting on a hard surface and is shaking, something is either on the fan or brushroller putting it out of alignment. Here is how to change the fan / impeller if broken.
how to change Kirby fan / impeller.
If it shakes while you are pushing against the carpeting you can try adjusting the height of the brush until it is just touching the carpeting. Some thick pile carpeting the Kirby will still shake or jump on, the strong suction causes it to trip over the thick pile that is lifted up when vacuuming.
GoodVac.com
www.goodvac.com
1-800-775-6586
How do i get shampoorowork
hellllllo.......shampooooooo........just went to goggle shampoo everywhere..........4/5 videos will help you............g.scott
Not finding what you are looking for?
