20 Most Recent
Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher - Page 3 Questions & Answers
Fisher and Paykel DD603 can't be drained completely
https://www.manualslib.com/manual/575481/Fisher-And-Paykel-Dishdrawer-Dd603.html?page=22#manual this link takes you to the service manual for your machine, there will be details on manually testing individual components, you should be able to operate the pump and check that it is performing as it should, page 39 describes the process to lift out the rotor, do that and check the rotor impeller, this is the drain pump, if the rotor vanes are broken you will need to replace it,
F&P dishwasher (DD603i) has no power to top drawer
No power to the top drawer needs to be verified.
Are you saying the lights are blank and when you press the start buttion nothing happens?
One reason the controller can shut the power is that the heater overload protection thermal resistor has opened. Unfortunately the only way to fix this is to replace the entire heater plate at the bottom of the drawer.
To confirm if the controller is operational or not, press Keylock and Start/ Pause button together for 5 sec (press Keylock first) and see if the Lights light up. If nothing happens then either the power has shutoff as mentioned above or controller is faulty.
Depending on your familiarity with such equipment you could try to replace and fix. I am not quite sure what the new model you mention is. I believe all DD603 models have power to the 2 drawers coming from the base board.
DD24DCX7 Dishwasher - Top Drawer Not Working
Hi Brendan,The dishwasher will stop mid cycle if the door is not closed properly, please ensure that the door is shut firmly and the latch engages fully.Also a broken door latch, faulty control panel or failed electronic control board could be causing the problem.Hope this helps.Best,Dan
Model DD603. Why wasn't flood sensor working?
F1 Flood should have triggered. There is a small, 2 post sensor located under the cover and parts assembly (to the right hand side) of the Mains board (under the plastic cover in the left, lower, rear portion of the base - under the bottom drawer - #10 & 19 in the drawing) and this should trigger with a very small amount of water in the base pan. Maybe dirty, bent or disconnected sensor?? Otherwise, likely a bad comms harness or control board. This is very unusual - never encountered it in 20 years of F&P service. I personally have two of them. One of our kids have it too. We love the F&P dishdrawers.Note: to actually get correct parts you MUST have the full model and product codes.
Error E45 on fisher & paykle dishwasher
Reset Procedures for the Fisher & Paykel Dishwasher
- Press and hold the button decorated with the key and lock image for five seconds.
- Press the power button to turn off power to the Fisher & Paykel dishwasher.
- Wait a few minutes and then press the power button to restore power.
- Turn off and unplug the dishwasher if the issue remains.
Not finding what you are looking for?
