You may have a stuck button as this will cause flashing of lights, try pushing button and see if it returns if not strike lightly above it with plastic spoon etc.

If this does not work u can buy the control panel from Sears for 190.00 but first go to searspartsdirect.com then type your model no. In required space click on shop parts on appropriate model, then go to troubleshooting then to won't start, then go down to how to replace control panel.

According to instructions you will only need torx screwdriver and less than 30 minutes to replace.

Kenmore 16602 /... | Answered on Jul 14, 2017

0 Answers

Kenmore 665.15522/15529: dishwasher runs but no water flows anywhere

Kenmore 16602 /... | Posted on Jun 07, 2017 | Be the first to answer

1 Answer

Water will not drain out of the bottom all of the sudden. How do I fix this?

???????????

Kenmore 16602 /... | Answered on Oct 26, 2015

0 Answers

How to replace detergent door

Kenmore 16602 /... | Posted on Jun 15, 2014 | Be the first to answer

0 Answers

I have a kenmore dishwasher model 665 the lock button is flashing and i press the no heat dry button for 4 seconds and this does not unlock the controls please help

Kenmore 16602 /... | Posted on Jun 10, 2014 | Be the first to answer

1 Answer

Locked light is stuck on

Are you pushing the button repeatedly or pushing it once and and holding it on for 4-5 seconds? Just push and hold it on for a few seconds till the lock light goes off.

Kenmore 16602 /... | Answered on Jun 09, 2014

0 Answers

Kenmore Elite Dishwasher 6651277K310 will not start

Kenmore 16602 /... | Posted on Jun 08, 2014 | Be the first to answer

1 Answer

Now the lucked light is stuck on

You might be refering to the locked light. Refer answer to your other post on the same topic.

http://www.fixya.com/support/t24503657-locked_light_stuck

Kenmore 16602 /... | Answered on May 28, 2014

2 Answers

I have a kenmore dishwasher mode 665.16032402

I was able to reset it using this procedure:

1. Crack the dook open

2. Within 3 seconds, press these buttons in this squence: Hi Temp Wash, Heated dry, Hi Temp Wash, Heated Dry

3. Close door

4. Press Cancel

That should clear the Blinking LED. It appears this is a common problem. The worst thing is they charge to come out for this.

Kenmore 16602 /... | Answered on Apr 03, 2014

20 Answers

Kenmore dishwasher wont start blinking clean light

today January 9, 2009...blinking clean light, kenmore dishwasher would not run,,,the solution on Fixya ..."keep hitting normal -heated wash-normal -heated wash buttons over and over...unlocked the blinking green light problem. Dishwasher is running as I type this....will post again when I see the results of another washing tomorrow. H.T. Las Vegas Nv

Kenmore 16602 /... | Answered on Feb 11, 2014

1 Answer