20 Most Recent
Kenmore 17252 Free-standing Dishwasher - Page 5 Questions & Answers
Kenmore dishwasher won't run
Common solutions for: Kenmore Dishwasher will not start. The door switch prevents the dishwasher from running and working while the door is open. If the door switch is defective, the switch will stop the dishwasher from running even when the door is closed. If the thermal fuse has blown , it will prevent the dishwasher from starting.
Make sure your dishwasher is fully and also securely plugged in and that the circuit breaker switches haven't been tripped. .It also houses the door latch switch that provides the power to the dishwasher controls. If the dishwasher door isn't closed properly, the dishwasher won't receive power to finish a wash cycle You could call a repair person that fixes dishwashers to have a look at it and see what the problem is with the dishwasher
9/5/2020 5:46:58 AM •
on Sep 05, 2020
Kenmore dishwasher runs bout 5seconds then stops
check it has salt in the bottom tank. check the out pipe is not blocked or bent/twisted. check water feed is working and the filter in the line is clear. ( filter is in the machine side of the pipe you need to turn off water and remove the pipe at this end to get to the filter)
1/9/2020 3:20:50 AM •
on Jan 09, 2020
Kenmore ultra dishwasher the top rack is not getting any water? cleaning
The first thing to do is visually check to make sure the water connections from the sump assembly to the top spray arm is all in good shape and connected, also make sure the spray arms ports are clear of any foreign material. Make sure that the top rack is seating properly to the water tube in the back of the machine. If this is all good it is possible that the diverter valve is malfunctioning. If it comes down to the diverter valve I would recommend that an authorized repair company assist you as they can be a trick and quite involved.
9/10/2019 2:45:30 PM •
on Sep 10, 2019
This is a 15972 that does not drain. I think the
The first question I have is did this issue start after a garbage disposal was installed? There is a plug in a new disposal that needs to be removed. If this is not the case the easiest thing to do is pull the dishwasher out. Be careful not to damage the floor or countertop. Tip the dishwasher back and put a cakepan or something under the drain pump to keep the mess to a minimum.
Remove the drain pump. Make sure you check the impeller is not loose on the shaft or broken and of course clean the ports.
I hope this helps.
9/10/2019 2:03:35 PM •
on Sep 10, 2019
Not finding what you are looking for?