Top 20 Kenmore 98702 Stacked Washer/Dryer Questions & Answers


not sure but go here...

https://www.repairclinic.com/Shop-For-Parts/a17b6c7i920d183467/Model-41799370120-Kenmore-Washer-Dryer-Combo-Belt-Drive-Belt-Parts
check if the oem # match what you have. if it's oem.
there's a video on the second belt on the list that might help you
hope so.

Kenmore 98702... | 136 views | 0 helpful votes


There is a sensor and if the weight of the load is to great it will not go into spin cycle

Kenmore 98702... | 150 views | 0 helpful votes


go to the manufactures website and get a user manual as the information you want will ben in there( how to install the machine) eric

Kenmore 98702... | 96 views | 0 helpful votes


sounds like one of the idler roller on drum is bad,not hard to fix,and dont cost much,you can youtube and see how to fix

Kenmore 98702... | 253 views | 0 helpful votes


You may have a broken pump belt, or belt may have fell off pump pulley. Another possibility is that you have a bad clog before the pump keeping water from draining. Your machine will agitate because this is a separate belt. Good Luck Friend.

Kenmore 98702... | 155 views | 0 helpful votes


Check your pressure switch ...or even the pressure hose is probably clogged...Reason for agitation issues.

Kenmore 98702... | 505 views | 0 helpful votes


Possible Shorted dryer heating element.

Kenmore 98702... | 173 views | 0 helpful votes


call a service technician to get a proper diagnosis and quote then decide to fix or junk

Kenmore 98702... | 161 views | 0 helpful votes


You need this to launch the procedure of creating your Citibank online login ID so prior to Citicards Login You will certainly currently be revealed your Citibank online login.

Kenmore 98702... | 332 views | 0 helpful votes


Dump the appliance. sears delivers the worst garbage available

Kenmore 98702... | 173 views | 0 helpful votes


The water pump could be stuck, or broken so the pulley on the pump is not spinning, while the belt is, which gives you the burning smell. Could also mean the motor is overheating giving you the burning smell. You will have to open the back and observe whats happening while its running. Just keep your hands clear while its working.

Kenmore 98702... | 389 views | 1 helpful votes


Hi
You'll need to find some one who can read the wiring diagram.
The best bet would be to call a repairer who specialises in your brand..
I've had to walk away from jobs which some one else has started, so don't say that someone has started to 'fix' it or they may refuse to work on it.

Good luck
Nomess

Kenmore 98702... | 104 views | 0 helpful votes


Correct the wiring. Manuals are available on line. You need to get somebody that can read the diagram.

Kenmore 98702... | 81 views | 0 helpful votes


Hello, this is Ava with Think Crucial.

You may find the User's Manual for your Kenmore model by clicking the link below.

Kenmore 93901 Series Use And Care Manual

You can purchase a wide variety of high quality appliances replacement parts direct from Think Crucial with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

https://www.thinkcrucial.com/collections/appliances

I hope this was helpful.

Ava B.
Think Crucial Customer Care
http://www.thinkcrucial.com/

Kenmore 98702... | 373 views | 0 helpful votes


I don't know where you have your washing machine but can't you just put the drain hose in the tub, or toilet to see if it drains? if either of those aren't close enough to dump discharge water into from your spin cycle, you may be able to add a short piece of clear tubing at the end of the existing hose using whatever connector you need to use, then put the hose back into your drain. This way you should be able to see if the pump is working. You can usually hear/feel water being discharged out of the discharge hose but I don't know what your situation is.

Kenmore 98702... | 233 views | 0 helpful votes


unless you know a lot about electrical don't attempt it. Remove the slanted part above the washed(two screws) then the two screws from the control panel. finesse the panel down. find and remove and TAPE AROUND the wires to the buzzer. replace in reverse manner. if you need help call me 573 330 1193

Kenmore 98702... | 164 views | 0 helpful votes


It sounds like something is stuck in between your spin basket and outer tub. Its recommended that get the repair manual for this model.

Kenmore 98702... | 70 views | 1 helpful votes


Check Heating elements if ok check the in line fuse that go to drying element and if it open replace it and clean filter and check pipe that blow out side make sure it not stop up because if in line fuse is open stop up filter and pipe that blow air out side will cause the heating element in fuse to open up. And check for lose wire going to element to.

Kenmore 98702... | 116 views | 0 helpful votes

Not finding what you are looking for?
Kenmore 98702 Stacked Washer/Dryer Logo

1,103 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Paul Carew

Level 3 Expert

3527 Answers

Nicola Conroy

Level 3 Expert

1428 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Washing Machines

  • Kenmore Washing Machines

Most Popular Question

washer agitates but will not spin

  • Washing Machines
Loading...