20 Most Recent Kenmore 98702 Stacked Washer/Dryer - Page 6 Questions & Answers


dryer has power, washer has no button function, no power showing , although on same circuit...??? any suggestions from anyone..

Kenmore 98702... | Answered on Dec 23, 2013


I am not much of an expert with dryers but i'll give it a stab. Should there be a filter that catches the lint so that it does not go all over the clothes? Have you got the manual. If not, see if you can find the manual online and see if there is anything mentioned about a lint filter.

Kenmore 98702... | Answered on Dec 14, 2013


If the dryer model number begins with 417, the drum is supported by a ball bearing in back, and a seal and glides up front. Often, the bearing will become very dry, either from years of use, or from excessive lint blowing up into the bearing. If the bearing isn't cracked or otherwise noticeably bad, you can usually solve the issue simply by lubing the bearing with a high temp grease. While the machine is apart...(a major pain in the butt), make sure to check the condition of the seal and glides on the front panel, and replace the belt if it looks at all cracked or frayed.
If this dryer is not a 417 and/or does not have a rear bearing, it's best to get a maintainance kit (belt, idler pulley and drum rollers) and install all the aforementioned parts, as they are the most likely source of screech. Also, check the motor by spinning the shaft manually with the belt off....if that is squeeking, it's motor
time.

Kenmore 98702... | Answered on Dec 02, 2013


Down low on the front should be two screws holding the front cover on. Hopefully the pump is accessable.

Kenmore 98702... | Answered on Dec 01, 2013


Remove screws at bottom of front panel. slide front panel down to remove and gain access to machine

Kenmore 98702... | Answered on Nov 21, 2013


washer timer, or door lid lock , check volt in water solniod

Kenmore 98702... | Answered on Nov 11, 2013


Check the hoses on back of washer for leaks. Clean out dryer hose from dryer to outside.

Kenmore 98702... | Answered on Nov 09, 2013


Sometimes there is a GFI or ground fault interrupter switch in the circuit. This is a wall plate which has a mini switch between both plug-in holes in the wall plate. Sometimes these are wired in-line where you have 1 master and additional outlets. This means that if the wall plate your washer and dryer are plugged into does not have a little red or black button to push to reset, there may be another wall plate in that room which has it instead.

Sometimes circuit breakers in a fuse panel are marked wrong. You may need to reset a different breaker.

Kenmore 98702... | Answered on Sep 23, 2013

Not finding what you are looking for?
Kenmore 98702 Stacked Washer/Dryer Logo

1,103 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Paul Carew

Level 3 Expert

3527 Answers

Nicola Conroy

Level 3 Expert

1428 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Washing Machines

  • Kenmore Washing Machines

Most Popular Question

washer agitates but will not spin

  • Washing Machines
Loading...