20 Most Recent HP Photosmart Premium C309A All-In-One Printer - Page 2 Questions & Answers

no - enable snmp protocol in windows 8 https://www.loadtestingtool.com/blog/general/how-to-setup-snmp-monitoring-of-windows-system/ https://www.garlandtechnology.com/blog/enable-snmp-on-windows-8

http://www.pc4cracked.com/2017/07/winzip-pro-21-crack

This video will show how to remove a part to get to a stuck piece in your printer's ADF. Hope it helps: WP_20170601_002.mp4 http://www.303electronics.com/ If you need further help, I’m available over the phone at https://www.6ya.com/expert/alex_22751bbefa74c3d0

Disable all device power saving settings in Printer and also in system power settings,that's it.

download from HP site and reinstall

Either the carriage is jammed or there is a major electronic board failure. With the power disconnected, try to move the carriage back and forth with your hand. If it seems sticky, clean off the carriage rod and put a drop of light oil on it. Then work the carriage back and forth until it moves freely. Plug in and all should be well. If this does not help and you can't find any jammed paper or objects, you have a major failure and it will be cheapest to buy a new unit.

It could be a problem with settings or installation of your printer. We would suggest you to check on settings.

change the USB PORT

Hi! I have an HP8610 printer that was having the same problem. What was causing the problem of disconnection was the wireless router being in one room and the printer was in another room further away. The signal was being weakened by having to travel through walls, various furniture, other electronic devices, etc. to get to the printer. Sometimes the signal from the service provider was stronger on some days than others. My solution was to remove any possible interference of the signal to the printer. I relocated the router closer to the printer, such that the signal didn't have to travel through 2-3 walls, and reduced any other obstacles. I also relocated the printer from the corner of the room, to a more open area to allow the signal easier access to the printer.
After I made these simple changes, I did not experience any further disconnections. I hope this helps you.

it should take the XL if you having issues inserting it give HP a call they will assist you

replace the cartridge.