20 Most Recent DISH Network 721 DVR Remote Control - Page 2 Questions & Answers

The easiest solution if you have tried new batteries is to request a replacement remote. This may be done at no cost to you depending on your specific circumstances regarding your account.

Thanks for using Fix Ya.com.

hi! i have here a couple of codes for your tv! just try them 1004, 1007, 1018, 1027, 1047, 1056, 1057, 1059, 1060, 1061, 1103, 1124, 1145, 1150, 1153, 1279, 1296, 1387, 1464, 1483,1046, 1465,1150, 2092, 1464, 2408, 1465, 2260, 1027, 2064, 3105, 1124, 2078, 3088, 1296, 2213, 3147, 1145, 3095, hope this helps!!! goodluck!!!

open your remote and look if you dont have a bad soldering some where use a good magnifier
if all look good its could be the ir led blow or the
xtal frequency controler.it as to be some ting like that
hope that will help ;sometime the batterry look full or test over 1.5 but theres not good replaced before to be shure..
have a nice day

Press menu -menu on the receiver. You should be able to see the remote address for the receiver. It will typically be set to 1 if it reset somehow but whatever the case make note of this number. Take the remote and hold the SAT button until all lights across the top illuminate. Now key in the two digit address- single digit numbers are preceded by a 0. Now press the pound sign in the lower right of the remote and observe that the SAT button flashes thrice. Now press the record button a few time to ensure it is locked. Now try exiting the menu screen with the remote.

If this does not work check the antenna on the back of the receiver and put it in the full vertical position and try again. If this fails you may need a new remote.
Thanks for using for using Fix Ya.
Ihope this resolves your issue.

This will be due to either your Hard Drive crashing if you cant also access your recordings. if so then i would reccommend call dish At 800-333-3474 bercause your 721 DVR is outdated and discontinued. It also is in patent dispute with tivo. When you contact dish they will offer you a new dual tuner DVR reciver with way more recording time. this upgrade should be free of charge as well.

If the dish network remote control is universal it may work with limited functions. If the remote control has buttons labeled cd, receiver, cable or Aux etc. it might work. The manual will tell you for sure. It will also provide you with the proper code for the component to work.

SORRY BUT WE KNOW OF NO FIX FOR YOUR PROBLEM

This website: https://universalremote.codes/dish-network/

you need to ask the people from dish not diyer's

Contact dish to inquire. Their remote control may or may not contain the applicable code.

https://www.youtube.com/watch?v=iyvBW5H88ow

Here is the user guide for the remote: http://www.yamaha.com/yamahavgn/Documents/YEC/Other/RX-V567_Programing_remote_control_codes_for_TV_Control_Key_operations.pdf

No codes needed just use the TV pairing wizard under the remote control settings. See the guide below...

Call Dish and check if your service is active, then have them send a programming authorization hit to your 722.

See the website here:

Yellow plug in is the green on at the top.

Contact Dish customer support: 800-333-3474

Call Dish and have programming hit sent to your receiver. This will solve your problem.

See the guide:

Call Dish to have a tech visit set up for you.