20 Most Recent
Elna Heirloom Edition 6005 - Page 9 Questions & Answers
How do I remove scorch residue from my Elna Press?
invert the open press on a heat proof surface, so that the heating shoe is on the lower area and the wooden board is above, balance it on a towel or similar so its stable as it will be sitting on one of the upper handles. Now plug in and turn the heat up. Use a protective glove like oven mitt, the shoe is VERY hot. Rub over the surface with an iron cleaning stick, let it heat up and smoke (do it in a well ventilated area), then rub off the residue with a big wad of rag taking care not to touch the shoe. Alternatively theres a cream product called iron magic, will do much the same thing. The last option which works on irons, is a panadol tablet, but you need to hold it with tweezers and rub over the baked on gunk. Keep cleaning and rubbing off until you've removed the burned on material. Use a rajah or pressing cloth when ironing anything with a decal on the front, or using press to apply interfacing.
How to oil an Elna air electronic tsp 58
remove the needle plate and the bobbin, there's two spots marked with red, in centre of the bobbin case place a drop of good quality sewing machine oil, and also to the left on the case, beside the tension dial. A drop in both, then run the machine slowly for a minute until the oil has spread through the innards. You can also remove the top cover but this is not covered in the manual as there's the recommendation in the manual to have your machine serviced annually. However, it can be done, unplug, then undo the two screws on top which hold the top cover on. Push down the spool holders, then wiggle the top panel around the lifting handle so you can slide the top panel vertically to the back around the handle. Then look down and oil on the needle bar bearing, turn the flywheel towards you to go through the stitch cycle and you will see the bearing coming around, drop of oil onto it. DONT oil on the right side near the friction drive and motor, just on the left area, metal on metal moving parts.
How to replace the drive belt on a Elna Supermatic
For Elna Star 62C (SU) machines that have no motor belt. If the motor pulley is damage or slipping. This part can be expensive or not available. Check out my solution to Elna motor pulley repair at very little cost at https://youtu.be/mpNmeSZ6_HE
User Guide for Contessa MO 103 Overlocker
Hi Nikita,
I also am after the manual for the Elna contessa mo-103 and was wondering if you might be able to scan and email it to me? Am going crazy trying to get it threaded and tensioned correctly!!
Thanks
Elna Grasshopper Smoking?
First DON'T use it if it is smoking. There is a serious risk of a fire or electric shock!! The inside parts of the motor are badly worn and need to be replaced or rebuilt. You will need to take it to a specialist to repair this as it is NOT safe to use until you do repair it.
Elna pro quilting queen e-1 error
The foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) and the reverse/reinforcement stitch button was pressed while the presser foot is raised. Lower the presser foot lever before continuing the operation
Not finding what you are looking for?