20 Most Recent Euro-Pro 9105 Computerized Sewing Machine - Page 3 Questions & Answers

it may be jammed with caught pieces of thread. try taking the cover off and cleaning it out.

Check to make sure that the needle is inserted correctly and that it is perfectly straight and not bent.

Wise not to use it until you have the proper slide plate

Call Euro-Pro's customer service for sewing machines at 800-787-7395. They can walk you through some solutions and if nothing else charge a labor fee of $40 to service it. The Euro-Pro model 9110 is supposed to have a 25 year warranty so you should be able get it fixed without too much hassle.

Yes,

Go buy a can of canned air from a computer store and blow out your bobbin case area and any other lint you see.

Then place a drop of of on the needle bar (right above the screw that holds the needle in) and one drop where the hook (silver part) goes around the bobbin case (black part that holds the bobbin case) (see picture)


-Chris

Try this diagram page .. see if it helps ..

http://www.sewusa.com/Threading_Diagrams/Threading_Pages/Euro_Pro_Sewing_Machine_Threading/euro_pro_9101_threading_diagram.htm

Please Vote !!

The online manual is located at:
http://www.euro-pro.com/europro/manuals/9105.pdf

http://www.euro-pro.com/europro/manuals/9105.pdf

Hi,

I checked with the user manual and found that with twin needles you can do Zig Zag stitiching. So your model is not only for straight stiching.

Please check page 49 of the manual.

http://ec1.images-amazon.com/media/i3d/01/A/man-migrate/MANUAL000060921.pdf

Thanks

Have a nice day.

Needs a new circuit board.

There is no speed adjust, but 1st you must know the source of the slow down. Remove the belt from the motor pulley and run it, if it goes fast try turning the hand wheel if it is stiff the machine needs clean and oil. If it turns freely you motor may be dirty or just slow. If dirty, sometimes you can without the blet attached run it at full speed for 10 to 15 minutes. It should get faster as you run it. If not motor is weak or slow needs replace. Just replacement motor as genuine probably no longer available.

When you set the switch for the feed dogs to be in the up position, turn the handwheel 1 complete revolution and they should come up.

Hello. The thread from the bobbin should start to creep up towards the feed dogs and make a loop that the needle and thread can "grab" to pull it up thru the hole for stitching. You might want to slowly put the needle down thru the feed dogs and then slowly with the winder not the pedal but with the winder slowly bring the needle up again. Try this a few times and see if the needle and bring it up. I've had it take a few tries; it doesn't always bring it up the 1st time. Regards, Joe

I've never had an auto needle threader work properly for very long. My suggestion is to not bother to replace it and just relearn how to thread the needle. Sorry.

Contact HSN and tell them you are not satisfied with it that it arrived defective. They will probably ask, then tell them so they can send you a manual, be sure to get the person's name and there address so you can follow up with a confirmation of the conversation. There is an implied warranty that it is usable as described and without a manual you cannot do that. They will Do it asap, in some states you have only a very short time to respond.
Good Luck,
Gilshultz

Call Euro-Pro at 1-800-361-4639, you can buy one from them. I had a problem with my bobbin holder and they sent me a new one within a week. I also ordered a set of 24 empty bobbins and the total cost with shipping was about $35.00.
Marge