20 Most Recent
Questions & Answers
Pressor foot will not completely
Good day to you!!!
I am suggesting you to put an oil to that pressor foot and also all parts which you think need to be oiled so that it become soft and easy to use..
If this suggestion does not help please have a comment so that we can make another steps/solution to it...
Thank you and please do not forget to testify and rate me when it helps you...
Pfaff 6122 Problem
Your machine just needs to be tuned up an the part inside that lower and raises the presser foot needs to be re-lubricated. Lint, dust, dryness and the machine not being used can cause this issue with most pfaff machines (including my 7570). A standard tune up from your local PFAFF dealer will remedy this.
Pfaff 1475 Needs to ''warm up?''
I had the same problem with my Pfaff 1475CD. If I waited about an hour or so it would come on. I have read here and elsewhere that you should replace the (5) 22 microfarad 16V capacitors on the circuit board. I ordered capacitors from Amazon and did this since I have a little bit of soldering skill. It worked! Machine now turns on normally. Note: you must pay attention to the polarity of the capacitors when replacing them.
Resetting the code
The 7550 has a battery backup (little door on bottom of machine - 2 AA batteries). Remove batteries for a couple of days and the code should disappear. Removing the batteries WILL NOT effect the main memory of the machine - they are just for the backup of any personally designed stitches and memory combinations - not the hard memory of the machine. Periodically these batteries will need to be changed - a message will pop up on the screen to let you know.
Hope this helps (ex-Pfaff employee - GREAT MACHINE!)
i also need the diagrams.i tryed many way to find it.but it dosent work.
anyway im repairing efka & quick rotan by myself without any diagrams.
if you like i can share my knowledge with you.
email me .
first sms me .00940772532280
How do I take the top off a Pfaff 7570
The top is also attached with some clips to the front and back of the machine. The handle also needs to be removed after you loosen up the top. It is held on with some C clips. The best way to remove thread is to separate the needle bar from the upper shaft. This may require some experience to get it back into adjustment. Good luck if you try this on your own.
I have a Pfaff 7570 with Windows 7 professional.
I can't tell you much or offer any advice but I can tell you with absolute certainty the Windows 7 compatibility programme has never worked for me.
I have stuff I used to use with XP and either it works with 7 or it doesn't and if it doesn't the compatibility programme makes not a jot of difference.
Not finding what you are looking for?