20 Most Recent
Copystar CS-1810 Copier - Page 3 Questions & Answers
Our Copier is printing with
u can take the fuser out and scrape the hot roller with a cardboard,but realisticly a new fuser or at least a new hot roller will be needed.new toner had nothing to do with it
Comes up with 710 code
Hi
Thanks for
using FixYa. You’ll need to run U163 simulation to reset and fix the error code 710. To find
simulation control service you’ll need to press cancel + start + light and release
all of them and press cancel. For getting the display 1, 6, and 3, then press
the zoom in and out. After 163 will display press start and the issue will be
resolved. If still the code is shown then there is a problem with the fuser
unit.
Please do
accept the solution if the issue is resolved or else revert for further
assistance.
Thanks
Rylee
Hi I have a copystar CS 1810 and it started to
Hello sir; It's a fuser problem, but you need to reset, the procedure as follow; Press and holding down following keys in order, "stop/reset", "start", and "left copy density", then press "stop/reset" key again, then enter U63 press "start", window will display "CLE", press start again to clear.
Code e70 on copystar 1810
Jam code 70 means: No origional feed. Paper is detected on the doc feedr tray, but when the start button is pushed - the origional don't feed through.
What does ap mean
"AP" stands for Agitation in Process", it appears in the copy quantity display when toner is being replenished inside of the copier. Wait a few minutes..this happens after continuously copying for long periods, or copying dense things like photos. Sometimes it will occur after running the machine when it is out of toner. replace toner and turn on/off a few times to "agitate toner. Don't worry about the scan lamp being lit while this is happening, it will go out.
Hope this helps
MY 1810, i GET AN
hi
the AP means that the copier needs more than one cycle to add toner.
This usually happens when the copier is used for a whiile after the add toner message comes on
COPYSTAR CS-1810
Hello sir; "AP" isn't a problem, just let it run for a little while, it will disappear.
Copystar CS-1810
You need to run sim U163 to reset fixing heater problems. Press and
hold stop, start, and left exposure key in that order. Release and
press stop again. Use zoom keys to enter 163, press start. Exit the
mode by entering 001 and start, or power off/on.
Not finding what you are looking for?