20 Most Recent Copystar CS-2030 Copier - Page 4 Questions & Answers

C710 Interrupted Communication at the Destination. If you're the sender, it's happening outside your machine. Most likely, phone line.

Did you disconnect telephone line?
C710: Interrupted Communication at the Destination.
If you're the sender, it's happening outside your machine.
Most likely, phone line

if this were your problem it would be obvious the inner tray is in the middle of the machine there is a lever that lifts up as paper stacks up its probably stuck in raised position

This code is a high temperature in the fuser unit. The reset process is as follows, enter 1087-1087-163-print button-execute-print button then shut machine off when the message comes up on the display. The machine should clear the code and reboot, if the code returns you will need to contact a service company for further assistance. Hope this helps.

You first need to pull the fuser out and manually check that it is running smoothly. More times than not, it will be the fuser rather than the motor.

If the fuser is fine, locate the motor then turn the machine on and visually inspect. If the motor does not run before the code pops up then replace it.

Bad Hard Drive

Paper jam in the paper cassette

There is still a jam inside the copier

Sounds to me like you need a developer change and these machines must have OEM toner

fuser problem

try 1087 1087 then 20 and 21

1087 1087 then 201 push little crosses with pen tip

try youtube or google iys hard to explain you have to remove the gray

it is the touchscreen

Make sure your default settings are for AUTO paper selection and 100% magnification to start. That is the most common default settings. Then, under "Zoom" change to AUTO magnification and under PAPER SELECTION specify Letter (either landscape or portrait). Now when you copy a legal original (8.5" x 14") it will be reduced at 78% to fit it on an 11" sheet. An alternative is to use "X-Y" zoom. Now you can stipulate 78% for the "X" dimension and leave the "Y" dimension at 100%. You will want letter size paper to be feeding lengthwise (portrait). Now you can copy legals and the image is reduced top-to-bottom only, leaving it much more readable.