Konica Minolta Di1610 Copier - Page 9 - Answered Questions & Fixed issues

Using the most current print drivers. Try this site

Clear the counters first then Replace the drum and developer run the required function codes should be good to go

Click File > Print to open the print window. Choose the Konica Minolta copier next to Printer. Click Copies & Pages - choose Quality from the list. Under Select Color, change the setting to Gray scale. https://services.dartmouth.edu/TDClient/1806/Portal/KB/ArticleDet?ID=64787 https://community.spiceworks.com/topic/235669-how-to-make-konica-minolta-print-only-black

what color is blank????

Replace the developer and drum if you can find them and run the F5 and F8

Fax board memory in operative. Replace the fax kit. Was it installed properly electrically. as in going into service mode and letting the machine know it has a board. have you attempted to update the firmware on the board.

Replace the drum and developer.

well I need the model???

Sir try this site

try this site

try this

Set the soft switch 18 -2 to one, currently at zero which means draw three inactive.

• Communication error between OACB/PRCB.
• Causes:Printer control board (PRCB) Overall control board (OACB) Loose connection

PCL connectionabnormalityE23-04(Di5510/It is checked that the movement of the blade motor (M14) is not completed, and the 24V power source is also checked. The drum READY1 signal (READY condition) cannot be detected within a specified period of time after the drum motor (M2) turns ON. Or, the drum READY1 signal (READY release condition) cannot be detected within a specified period of time after M2 turns OFF. At this time, an error detection signal (24V cut out) is detected.Causes:Drum motor (M2) Blade motor (M14) Printer control board (PRCB) Blade sensor /1 (PS30) Blade sensor /2 (PS31) DC power supply /2 (DCPS2) Wiring harness broken Loose connectionDi7210)Failure of PCL connection is detected.

REINSTALL IMAGING UNIT THEN PRESS THE SUB SWITCH AND ON IT BACK

replace the cyan and yellow image units Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

the sensor did not sense paper passing through fusing unit. check sensor by the side door, paper exit unit or paper passage clean sensor, change if broken check sensor spring

The incorrect Image processing board is installed Check connectors change image processing board

service all pick up and exit roller, or check the side door sensor, check of their spring returns.

https://printcopy.info/?mod=srch&inmod=erc&brand=Konica-Minolta&strSearch=Konica+minolta+368+cyan+abnormal+low+toner+density