Konica Minolta Di1610 Copier - Answered Questions & Fixed issues

Front cover is placed on front of machine. Should be some tabs near top, or on either side. If not, use finger nails or thin sturdy tool or object to pop open. Should be very little resistance. Don't force it. Should see all the guts of copier or whatever it may be. Usually can see the paper stuck in there. Good idea to unplug and try pulling jammed paper out. Close and restart.

this is PM call, some items may have reached to its life. consult Service Representative.

replace the developer and the drum, run required test and ensure counters are cleared Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Replace the developer after clearing counters and before running developer charge Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

sir Have you replaced the developer??? Did you clear the developer counter??? Before you remove old developer. Did you run the required Developer Charge after new developer was installed??? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

sir Have you replaced the developer??? Did you clear the developer counter??? Before you remove old developer. Did you run the required Developer Charge after new developer was installed??? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Have you replaced the developer??? Did you clear the developer counter??? Before you remove old developer. Did you run the required Developer Charge after new developer was installed??? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

something is wrong with the scanner located under the big glass the scanner is what move when you use the big glass or sens a document thru the doc feeder then the scanner move back towards the small glass Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

replace the drum and developer Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Replace the developer and drum and clear required counters Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

No such code please chk again. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

What is wrong with the job? or just resend the job Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

need a developer Dv-116 or try to -menu quick setting << quick setting <> (service mode) go to function and press auto TCR adjust press ok or need developer Dv-116

Where is paper jamming, bypass tray, 1 or 2 draw, exit, finisher? Inside the machine? When you print or when you copy or both? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

incorrect type of toner cartridge was installed. only use the toner cartridge that has been manufactured specifcally for this machine.

Incorrect T/C type means that toner cartridge have not good contact with toner chip, is good to clean this chip, or contact inside magine is not good. Change toner cartridge and if that problem remain, its needed replace contact unit on machine

C0954 mafunction

open then close the front door -> the display show " CHANGE DRUM ? YES/NO " -> press yes on the board

Try set manual,by pass tray.

please described