Top 20
Konica Minolta Di1610 Copier - Page 2 Questions & Answers
I need the Konica Minolta
The ip address is provided by your it department if you do not have an it department then you can select an ip address that is not being uesd example 192.168.1.200 this lus the sub net mask standard sub net mask 255.255.255.0 needs to be put in the network section of the machine then you can go to the c: prompt on your computer type in ping then the ip address you put into the machine you should get 4 replys and no drops then you will also need to load the print driver for the machine onto your computer
Can there be another problem
Power OFF/ON while holding the Panel Reset and No button, then access the tech mode and change the ADJUST in the TC type to 0 for USA.
C0520
- 1. Turn the machine OFF.
- 2. Press and hold the STOP key.
- 3. Power the machine ON and release the STOP button after 5 seconds.
Problem with di1610.always says change t/c-
TC type is set to the wrong value.
Set the TC type value to 5. To change this setting, perform the following:
1. Press Utility
2. Enter the Service Mode (Stop-0-0-Stop-0-1).
3. Select number 4 Display.
4. Scroll to TC Type.
5. Enter 5 and exit.
Inncorrect tc type
incorrect type of toner cartridge was installed. only use the toner cartridge that has been manufactured specifcally for this machine.
Minolta 1030 blank copies?
Hello George;After you replace the drum, you have to push drum unit and developer unit closer,and the fasten it if stll don't work go to check the charge unit see there have broken crona wire ,if they do repace it.
Not finding what you are looking for?