20 Most Recent Minolta EP1030/1030F CS/PRO Copier - Page 8 Questions & Answers

Magenta developer unit and or motor has the developer for the Magenta been replaced was it done properly? Was developer unit replace?????

Replace the drum and developer units

You can copy from the bypass tray but not print. Go to the paper select and select bypass tray ensure paper is properly oriented.

The developer has not been changed and needs to changed. The drum also need to be replaced.

IT is 16year old today, and there are no spare parts, for it. cept used on ebay. the blinking lights in the manual mean, toner cartridge dead or fake one installed. on page 11. if got it to work there are no windows 10 drivers, now. XP yes. see that page 11 states on errors. https://www.manualslib.com/manual/90066/Konica-Minolta-Magicolor-2400w.html?page=11#manual the service manual is here, https://www.manualslib.com/manual/805991/Konica-Minolta-Magicolor-2400w.html RTM?

I bet it must be grease free, it came like that.

Replace the drum and developer if it can be found and run the correct service procedure

Yes what about it????

This error code is for an Auto toner sensor issue. You should consult a technician.

1234567812345678 Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Which draw 1? 2? or 3? or the bypass tray on the side?

Does line go down the 11" side or across the 81/2? does it happen when you use document feeder? try on the big glass. slit glass maybe dirty the small glass used by the document feeder. start a copy stop it by opening up the machine during the copy cycle at temp to catch the paper under the drum is the line there? or after it comes out it could either be the drum/image unit or the fuser.

Replace the yellow image unit.

Default is 92729272 or 9272927292729272

M2 Call service.Maintenance M2, M1 Call service errors.To remove this error do the following steps.1-Press utility button on panel.2-Now press these buttons one by one, Press Stop, then zero, again zero, then stop,then press zero.3-its the code to get into service mode.4-After pressing above mentioned buttons you will enter into service mode.5-Now select service choice option.select it by pressing OK button.6-In service choice option you will see Maintenance count option.7-Select it by pressing Yes or OK button.8-There will be three options 0,1,2.9-Select 1, it will show a new menu, with numbers, now press C button to clear the counter.After the counter is cleared.Select 0 and press Reset button.

Have you replaced the image units and toner units with OEM parts Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

First copy slow generally next copy ok

Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA so please make sure. SportzCraazy Get all the Live Updates and Latest Sports News