Top 20 GE APH10AA Air Conditioner Questions & Answers

Most window units are circuit board controlled. Most all electrical circuits like the fan motor, compressor, and heating, are powered through the circuit board, and distributed through different circuits in that board(control board). I would guess you have a circuit board malfunction. It's possible the thermostat is sticking, allowing the control board to misread a return air temp. Without some troubleshooting it will be difficult to pinpoint the problem but I'd bet it's one of the two.

sounds like you are overcharged or possible blockage. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

it sounds you know something about electricals...okay,try to put the cord from the unit to your lower arm and feel it if it is getting warmer in temperature,or the switch cover of your a/c wall switch.if not it`s better you have clamp meter for ampere testing and voltage measurment

This unit has a famous problem with the control panel. Try to use the remote to turn it on, instead of the panel. I had the same problem.

Clean the filters

Take a shop vac **** out the water from pipe. then take vinegar put a litte back in pipe this will kill the algee in the line

with real high humididty this will be a problem I might suggest that you find some kind of pair and place it inside the pail but stacked onotp a a block to keep the unit dry until things dry out a bit .. Its the weather not the unit thats the problem let me know

If its a AC unit, you add no water. If its a humidifier you add water, but you do not want humidity this time of year.

I would check fan motor for oil ports and add a few drops of machine oil if they are there. Check fan blades and clean as good as possible. If you can hold on to fan and move motor shaft back and forth more then 1/8 inch then the bearing on yhe motor are worn and you will need to replace the motor. Thank you.

you will need to find the sensor/switch, which is in the housing where the drain bucket is located, it is either stuck or shorted. Good Luck Tim

You could try GE Parts Service. You will need the correct Model Number of your portable AC Unit to do this. https://www.geapplianceparts.com/GEApplianceParts/Dispatcher?REQUEST=LANDINGPAGE&AppliancePart=Air%20Conditioners


And you can also try Factory Appliance Parts. Again, you will need the correct Model Number .
http://www.appliancefactoryparts.com/airconditioners/ge/allmodels.html

Hope this helped to get you started. Please let me know. Thanks.

thats why they sold it, it is low on freon.

I have the same problem, Just use it with its remote control. if you dont have it you can order it through sears parts : part# DG11A2-04 (GE) or 81401789

You might try running the fan on a lower speed so that it does not blow so hard. Also, you appear to be in a high humidity area. Continue to run the unit to cool the room and as the humidity drops, The amount of water the unit is making will be reduced thus curing your problem.

Check coils for cleaning
Feel compressor for high heat
You may need a hardstart kit. Ask your nearest appliance parts man. Directions are usually on kit. Classified easy

If this was helpful please rate me.
Leo Ponder Appliance-Tyler,Texas
[email protected]

http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-7487.pdf

You don't pour water in that. It makes its own water. LOL
It shuts off when it gets full of water. I am not familiar with this dehumidifier but I know it holds 4 pints then the float comes up and kills the power. Take the cover off and I am sure you will find a tub full of H2O.
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi,
Here is a tip about trouble shooting your air conditioner...

Air Conditioner Trouble -Review the Possibilities
http://www.fixya.com/support/r3571569-air_conditioner_trouble_review_the_possi

heatman101

Hello there"
There are a couple of things here that you can try first is to geta garden hose and spray the entire back of the unit and flush it out really good cause if air cant get into there it will not work properly then make sure that it can drain properly once this is done test the unit out and see if this has helped but if not then take the front cover off the unit and you will see a small tube attached to the front of the unit if you can slide out the tube from the holder and as the unit is running on the coldest setting hold onto the end of the tube the heat from your hand will cause the termostate to attempt to make the compressor deliver more refrigerant this normally takes around 5 min but if there is no change than this is telling you that you have a low charge of refrigerant and should be refilled cause if you do not get it filled to the right amount of refrigerant you can burn up the compressor ok but if it does seem to work i would move the tube to a different area if possiable generally along the edge seems to work the best or i have even seen them left out of the part that they were connected to so that it is not continously resting on the unit and pointed down ok
Hope this is all very helpful for you please keep me posted on how the repairs are coming along
Best regards Michael

The air temperature is cooling the vents below the dew point, make sure the coil and filter are both clean, make sure the fan is clean too, if all of the above are ok it could be you just have a lot of humidity to deal with.