20 Most Recent GE 24 in. GSD5950 Built-in Dishwasher - Page 3 Questions & Answers

Could one of the hoses be buckled?

The one way flapper in the drain pump has broken off.

Unplug power cord for 3 mlns

Did you install it, or did the vendor install it? If it is brand new, contact the vendor for assistance or replacement under warranty

Shut off power to dishwasher at electric panel,shut off water supply,open door of dishwasher,remove screws on top side of dishwasher that are screwed into the underside of the countertop,,remove the front service panel on the bottom front face of the appliance by removing two or more screws on the right and left,locate and disconnect the water supply feed,locate and disconnect the electricity supply cable,locate and disconnect the drain hose usually connected to the drain of a nearby sink,pull dishwasher out of cavity in cabinet by grasping both sides of dishwasher with door slightly open,adjustment of front legs of appliance may be necessary.

E4 means dishwasher sensor is detecting the dishwasher is over filling. First thing I would check is the float. You will want to make sure it travels up and down freely. Open your dishwasher door all the way. Look on the right hand side (could be in a different location on your model) you will see a round thing. Kind of looks like a air hockey pusher. Try moving it slowly up and down making sure it’s not stuck open.
If this didn’t work then I would lean towards a faulty sensor.
It’s possible you could have a faulty board as well.
It is my opinion unplugging it will have no effect on this particular issue.
I hope this information has helped. God bless and have a great day.

I DON'T KNOW. INSPECT CHECK FUSES OR CIRCUIT BREAKERS. BE CAREFUL AND MEASURE FOR ELECTRICITY AT WALL RECEPTACLE.

This should solve your problem: https://www.manualslib.com/manual/1337459/Winterhalter-Pt-M.html

Hello, Not exactly sure of the problem you're having. Can you be more explicit?

Usually has a microswitch that connects when the door is closed. Check to see where the switch is and check to see if it is connecting.

The main pump motor may not be working. If you cant hear it running, it may be jammed up or burnt out. If you can hear a loud humming noise, its possible its only jammed. You will have to remove the pump and see if any foreign matter has stuck in the pump impellor. If the pump is running, check the small outlet holes in the spray arms, they may be blocked.

Bad timer. Sadly, the cost of replacing the time and the solenoid is likely prohibitive. Timer is expensive. Sorry, I know this is not what you want to hear.

Control board defective or washer pump.

Are you able to select cycles. Is there any water in the bottom of the dishwasher.

possible resrtriction, weak water pump!

Possibly not enough water. Water valve may need replacing

Check your manual http://www.manualsonline.com/

It is normal for there to water above the sump area on that model dishwasher. How this unit works is...the timer send voltage to the drain solenoid for a short period of time, then disconnects the power. The water pressure that is created by the pump is what **keeps** the drain valve open, until the water pressure/volume is low enough for the drain valve spring to overcome and the valve closes. I assume that you have cleaned the air gap out?

usually websites online for help with codes

If it is electrically activated, it is probably a loose wire from the timer control or possibly a bad timer switch.If it is mechanically activated, it may be a broken plastic part in the actuator or at the door itself. Good Luck..