20 Most Recent
GE 24 in. Profile PDW9880JSS Built-in Dishwasher - Page 3 Questions & Answers
PDWT300R10WW
Check the pump and filter for blockages as the dirty water may be not draining properly. A mix of detergents is ok. Run a prewash with the unit empty and see if the water is still greasy
5/10/2012 7:46:01 PM •
GE 24 in....
•
Answered
on May 10, 2012
What's your problem? Can I Use vinegar for hard water in my stainless steel dw?
better to use 3 oz of citric acid on a monthly basis, As an alternative you can use AFFRESH available at home depot or lowes, or GLISTEN available online but hard to find locally. if you use citric acid, make sure you have hot water at your sink, measure 3 oz and put into dispenser and remainder in the bottom. start washer on normal . NO DISHES,
1/7/2012 4:57:16 PM •
GE 24 in....
•
Answered
on Jan 07, 2012
GE Profile Dishwasher not cleaning - older PDW7880GOOSS
My GE Profile Dishwasher PDW8280N00SS wouldn't clean the dishes. I found what looked like plastic particles along with food particles in the wash arm spray holes. I found that heat had warped the gray flat filter in the bottom allowing food particles to bypass the filter, and I found that the flexible plastic sump inlet was disintegrating internally shedding plastic which clogged the filter to the pump and getting into the pump. This shouldn't happen. The material that the sump inlet is made out of is too soft and porous. I noticed other components in the wash water system made from the same white flexible rubber which is an unacceptable material. I bought replacement parts at a cost of $100 for both and this has solved the problem. What's distressing is that the replacement parts appear to be made of the same inferior plastic. And I have noticed upon closer inspection that additional interior parts appear to be heat damaged (warped). This dishwasher has been used less than 4 years and problems like these in a high end dishwasher are unacceptable.
12/26/2011 8:28:06 PM •
GE 24 in....
•
Answered
on Dec 26, 2011
GE Profile mod. # PDW7880J10SS not cleaning,
The problem is hard water. www.dishwasherfilter.com has a
product to solve this problem once and for all. It filters the water going into
your dishwasher and removes the hard minerals that leave those spots. It is
very affordable and even has a money back guarantee. You will love the way your
dishes look with this product.
11/20/2011 2:49:57 PM •
GE 24 in....
•
Answered
on Nov 20, 2011
GE PDW9280J00SS not draining. I
GE dishwashers use either a drain solenoid or a separate drain pump assembly. Sounds like your drain pump isn't getting power to it until you start other cycles, which sounds like control board issues.
9/25/2011 7:02:05 AM •
GE 24 in....
•
Answered
on Sep 25, 2011
I have a ge profile
http://www.geappliances.com/search/fast/infobase/10000380.htm
According to this link, it should reset after the power is shut off for awhile. Maybe try holding the start/reset button too. Also check the circuit breaker or any fuses
8/28/2011 8:39:26 PM •
GE 24 in....
•
Answered
on Aug 28, 2011
Machine turns on, water goes
Hi
The issue seems to be with the float
switch assembly that is bad and should be replaced. Float assembly is found
inside the dishwasher's tub, on the bottom. The water that fills the dishwasher
lifts the float, and when it reaches a certain level, it acts as a trigger for
the float switch. The float triggers the float switch to shut off, thereby
shutting off the flow of water into the dishwasher. A defective switch may
interfere with dishwasher's filling and/or draining ability. Use voltmeter to
test the switch. Set the device to the ohms setting x 1. Take each probe and
touch them to one switch terminal each. This should produce a reading of either
zero or infinity. Continue to touch the probes to the terminals, and press down
on the switch's button. The reading should change to the opposite extreme. If
the switch fails either of these tests, you should replace it. Hope this helps...please post back for
further assistance.
Daniel
8/27/2011 11:44:06 PM •
GE 24 in....
•
Answered
on Aug 27, 2011
Our GE Profile is'nt cleaning
Hi,
I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher
SprayArms not Spinning
How to Buy
ApplianceParts OnlineA bad heating element causes many problems in dishwashers...
Dishwasher Problems The
HeatingElement not WorkingDishwasherMaintenance
DishwasherResidue and Film on Dishes
heatman101
Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes
\][\
8/13/2011 1:14:35 AM •
GE 24 in....
•
Answered
on Aug 13, 2011
Not finding what you are looking for?