Top 20 Samsung SyncMaster 2333HD 23 in. LCD TV Questions & Answers

if there is no screw on the bottom of the stand that u can remove there is usually plastic clips that hold the stand in place.

Send your email ID to me by fixya, and get a copy of it by return mail. I can't send it to you by this window, as it do not allow me to do.

If you are sure that there is infrared emission from the remote control, replace the infrared sensor inside the TV. It can be located just behind the infrared window at its front panel. You have to open the TV to access it. There are many types of it. Some among them are illustrated here.

If the Display panel itself is damaged or bad buy another set as the part not counting labor will always cost more than the set did when new.

Consult the owner manual--if do not have that call Samsung or GOOGLE the model number with "manual" to locate the owner's manual.

Since your television does not have the standard composite input that the PS2 came with, you would need to purchase a new cord. The easiest one to use would most likely be the component cord that uses the RED GREEN BLUE for video and RED WHITE for audio. If you were to inquire at your local gaming store, they may be able to get you the cord that you need for your PS2.

What you'll need to do is set your TV to whatever input you're using on the laptop (VGA or HDMI). Then go into Display Properties, which can be found in Control Panel. Select the grayed out 2nd display and check "Extend desktop onto this monitor". Slide the resolution to something your TV can support such as 1366x768 or 1920x1080. Apply, OK, OK and you're done. The exact steps that you'll need is slightly different than the instructions here because of variation in TVs and OSes, but it's mostly identical.

its a snap-type plug-in stand, just hold the stand firmly and pull the monitor equally upward, then it will snap quickly....... but a proffessional reminder! Before mounting your SyncMaster on a wall, be sure to plug the two (2) stand holes located at the buttom of the monitor. My Samsung SyncMaster 2333HD LCD TV was twice intruded by adult-size lizard, both incident resulted to main power board damaged!!!!

White is your audio signal, not video. If you are using a composite hook up, yellow is your video and needs to go in the yellow slot. White and red is your left and right audio. If you are using a component hook up, then you will need to use red, green and blue for video and white and red for audio.

Hello,

Aim your remote control at your television.

Press the menu button on your remote control. A menu with several options will pop up on your television screen.
Scroll through the menu and find the "closed caption" option. The option might be labeled "Closed Caption" or "CC." There are four closed captioning modes. Once you open the closed caption sub-menu from the main menu, the screen will inform you which closed captioning mode is currently being displayed.
Disable closed captioning. From the closed caption sub-menu, find the option labeled "CC Off," "Disable Closed Captioning" or any variation of these titles. Once you select this option, you can exit the menu, and closed captioning will be turned off.
I hope the above helps. If it doesn't help, please let me know so that I may direct you further.

Good luck.

probably grounded "fly-back component" located at the main power board..... better check it by a authorized Technician!!!

your tv has a mark burnt in to it.

i have this same problem...have you found a solution?

yes are you using an NTSC,or PAL try and check the connecting and use the NTSC thts better it will give you a better pics you want .

Before scanning for channel, check to see if the Antenna input is set to Cable or Antenna. If you have rabbit ears or and outside antenna then set it to antenna. If you have cable then set it to cable. Then rescan for channels. If this has already been set then the next step is to check the antenna or cable feed. If possible plug the antenna or cable feed into another TV that is known to be working correctly. If it is capable of receiving digital channels then the problem is likely the Samsungs ATSC tuner and will require service.
If neither TV is getting Digital channels then I will need more info on your antenna setup and where you are located. I am a pro on TV antennas and reception.
Hope this helps
Have a great Day

Go to samsung.com and you can download for free.

for tv channel it tune as you select channel. just select air or cable channel.

The power supply on the unit needs repair. In some cases you can find a damaged one with good power and install the board. A good technician should be able to fix the unit for 80.00 or so. If you want to send the unit in to us we can usually have the repair completed in less than a week. Thanks

http://www.scribd.com/doc/26351010/Samsung-Lcd-Lb350-650-Training-Book

have a look at this service training manual..
It is switching off, as it is detecting a component that if it were allowed to be powered ON, may cause a fire, and explosion or both, so the set is switching OFF the PSU, for protection. You should remove this unit from the mains. Then the fault, clears, and it comes on again, this is called a "Hic-upping" power supply. You need to get it attended to by a professional. Please get an authorised service agent, and ask for a "Quote" for any repair.

just replace tuner and you'll be ok