20 Most Recent
GE 36 in. JGP628 Gas Cooktop - Page 6 Questions & Answers
GE cooktop ignitor jgp
Look for a short in the wiring (usually white wires running to the ignitors) or a loose ground wire. (usually green)
7/2/2012 8:37:56 PM •
GE Cooktops
•
Answered
on Jul 02, 2012
What does hard wire mean
Hard wiring means NOT a plug in, but rather wires are connected by an electrician, twisted together with wire nuts.
1/28/2012 5:20:51 PM •
GE Cooktops
•
Answered
on Jan 28, 2012
Large right/front burner is out
Hello,
The switch for the right front burner is defective and needs to be replaced,its bad as far as internally when turned on no matter what its set it the interal contact is stuck on only high so their is no setting it will work on except high. By replacing the switch it will work on the various settings and not just high.
GENE
9/23/2011 3:01:30 PM •
GE Cooktops
•
Answered
on Sep 23, 2011
The electric ignition on my
Hello,
The problem is one(or more) of the 4 switches that turn on the spark when that burner is turned on is shorted and stays closed (on) all the time.To determine which one it is the front face has to be removed,with THE POWER OFF a meter set to low ohms rating is used to check each switch by removing the wires to it and see which one has continunity (ZERO OHMS) when its off and that switch that slips on the burner valve shaft is the bad switch(s) and needs to be replaced to keep it from sparking all the time.
I hope this helps you to repair your cooktop,
Gene
8/8/2011 3:12:05 PM •
GE Cooktops
•
Answered
on Aug 08, 2011
Ignitor is spontaneously igiting
Hi hjaragon,
I believe your ignition switches have come in to contact with either water or moisture.
Please read my below Tip on how to fix the problem:
GAS KITCHEN APPLIANCE CLICKING SOUND...
If it does not solve your problem, I'd suggest replacing the ignition switches.
Kind Regards
JEDEMEYER1
* If you found this solution helpful, please rate it
8/3/2011 5:58:15 PM •
GE Cooktops
•
Answered
on Aug 03, 2011
My gas cooktop is contiuing a clicking sound to
Hello Blair
Does the clicking or spark stop with all knobs in off position? If so it's probably the one burner valve for the one you're trying to light ,stuck in light mode,sending signal to module.Have that burner valve replaced.($50). (2) If clicking continues even though everything is off, it could be any one of the burner valves or your ignition module is messed up .You would have to pull wire off each burner valve one by one to find the offending valve . If not valves then suspect ignition module.
Easily fixed either way.
Feedback appreciated !
8/3/2011 5:24:06 PM •
GE Cooktops
•
Answered
on Aug 03, 2011
Not finding what you are looking for?