20 Most Recent GE GTS22IBMWW Top Freezer Refrigerator - Page 8 Questions & Answers

BEHIND A GRILL IN THE FREEZER SECTION

USE A DIFFERENT THERMOMITER

Hello. The water inlet float is broken/inoperative in the freezer compartment of your refrigerator. This causes a overfill/flooding condition.

THEN YOU CALL A REPAIR SERVICE LOCALLY

This should be a warranty repair/replacement . Contact the place of purchase.

Power Resets https://removeandreplace.com/2016/02/02/refrigerator-display-panel-is-blank-not-working-how-to-reset/ or

Refrigerator - Dispenser Control Panel Not Working

products.geappliances.com > gea-support-search-content

SAVE UP TO $2000 on Select GE Profile Appliance Packages ... Unplug the refrigerator or turn it off at the circuit breaker for 30 seconds to reset the control. ... Try resetting the control panel by turning off power to the refrigerator briefly. ... For service, please schedule an appointment with GE Appliances Factory Service.

If you are talking F then that is too low at -10, F? is what is required.If C then the FF (whatever that means) at 40C is too hot and -20 is about right for a freezer.

Forty Years old? Time to retire.

Sounds like the compressor is not running,

I need someone to feel the top of the compressor. Is it cool, hot or too hot to keep your hand there? Usually on GE models like yours the=> WR55X11072 Main Control Board is the problem along with the start relay, overload and run capacitor. GE Refrigerator Model GSH25JSDD SS Parts I'm here should you have question, Thanks, Sea Breeze

The freezer controls the fresh side temp by letting the cold air through the divider. Make sure that the passage is not blocked or iced over. Also check the cooling coils to make sure they are clean.

Hold Energy Button & Light Button for 10 seconds!! No repairs needed. Solution is not in manual.

see if compressor running

I don't know - I would describe the noise as being like the wind blowing across a chimney. I have never owned a fridge that didn't make such a noise as it grew older - while it was on a cooling cycle and afterwards it sounds like water trickling. It doesn't seem to affect the performance though and I manage to ignore it.

Try unpluging for a day if possible.Ice can build at drain on some models.

the magnet seal arount the door needs to be replace, ypu can purchsase this and simply remove the old and and glue on the new one.

another quick fix method is to use a hax and staple type lock and screw the stape on the frodge and the hax on the door sor sfter you puch in the door simply staple it shut.

It is the job of the refrigeration system to move heat from inside the cabinet to the outside - that is why when it works correctly, the compressor runs and the condenser and some of the pipework becomes quite warm (hand hot in some cases). If this is happening it proves heat is being moved though if the cabinet doesn't become colder it is possible the heat that is being moved could be coming, in a frost free appliance, from the defrost heating element that must be permanently on due to a timer or thermostat fault. The defrost heater usually is switched on only for a short time at the end of each cooling cycle. If the condenser isn't warm while the compressor is running, it could be the compressor is broken or the refrigerant has leaked away.

check the gas of the refrigerator, due to lack of gas fridge can't process to freeze properly.

sometimes the water line in the back wall of freezer will freeze up so the water will not run into ice tray try using a hair dryer to heat the back wall long enough to thaw it out then turn freezer control down some..

black is live, hope this helps