20 Most Recent
GE Profile Arctica Stainless Steel Top Freezer Refrigerator - Page 6 Questions & Answers
Freezer n refrigerator is warm at 78 degrees
If the compressor is running it either has broken valves or the refrigerant has leaked out. Without knowing more than the information you've provided I would start with the basics. Does the fridge have power? Can you hear both the condenser and evaporator fans running? Have you checked the coils under the fridge to see if they are clean?
My GE Profile Artica ice maker is making ice, but
Hi!!
The Ice Maker and the Freezer/Fridge part of the unit work separate, that's why you get the ice made but the freezer can't keep it frozen.
Most likely the condenser, located in the back of the freezer is all frozen and covered with ice pluggin up the air ducts to the fridge, preventing it from cooling.
One quick solution will be unplugging the refrigerator and allowing it to defrost on it’s own or remove the freezer's back panel and using a heat gun or hair dryer to melt the ice, this will take about 20 to 30 min..
There are various reasons this type of problem:
The temp. controls are not set properly. Set controls according to manufacturer recomendation.
The small fan in the freezer is not working,
The defros timer is not working or,
The defrost heater coil is busted.
Once the ice is melted, plug unit back in and check for unit reactions. You should be able to hear the freezer fan working. Also, you'll hear about 4 to 6 times a day the defrost heater melting the ice in the back of the freezer, if NOT, check heater coil for continuity.
Don't forget to rate this post. Good Luck.
.
Freezer walls are icing up.
Most
likely with that model the problem is with the defrost heater burning out. Easy to spot after unplugging power from wall, removing contents and rear panel inside freezer. Use a hair dryer to speed things up. If burned out you will see smoked glass inside tube that holds the heater element. Click Here=>
WR51X10055
It does not hurt to change ot the defrost thermostat while inside part number Click Here=>
WR50X10028
Please rate my solution after I have helped you resolve the problem and communicate with me. I am offering my help to you free. If need you may contact me here on Fixya or my Forum=> Appliance 911 My contact information is located above the Fixya Ad on my blog here=> Sea Breeze Appliance Parts and Technical Services, www.pcappliancerepair.com
Thanks, Sea Breeze
5 year old refridgerator and freezer not at proper tempurture
You are right when you say that you would be facing heating experience. Normally the optimum temperature of a refrigerator is 37 degree fahrenheit, but in your case it is very much higher. You need not to worry about the heat from the motor, if it's functioning properly, that's enough. You are lucky that your refrigerator doesn't have overheating problem. Many refrigerator are having heating problem and more than that, they make annoying (humming sound). I suggest you not to do anything with it unless it is necessary. Good luck.
Chasnge light for water dispenser
Dispenser
Unplug the refrigerator.
The bulb is located on the dispenser
under the control panel.
Remove the light bulb by turning
it counterclockwise.
Replace the bulb with a bulb of the
same size and wattage.
Plug the refrigerator back in and you are ready to go!
Thanks, Sea Breeze
Older fridgidare side by side, fridge side is warm
Hi,
There could be a few reasons for insufficient cooling.A heavy frost build up on the back wall in the freezer, indicates it's probably not defrosting. As the frost gets thicker the refrigerator and freezer temperatures will get warmer and there will be no air flow to the fridge section. If you don't hear the motor running in the freezer, it will cause the same problem.
If there is no frost in the freezer and good air flow from the air baffle in the fridge section, then it will lead toward the seal system. This could be a restriction, low charge or the compressor may not be pumping properly. A technician will need to make these checks.
Hope this helps.
My ge profile artica pss25sgna bs does not get cold
Hi
Thanks for using FixYa. If you are sure that it is the compressor which is not receiving signal to work then it is usually a bad relay or a bad overload switch. You'll need to check both of them and replace whichever has gone bad, please check this picture part#733 is the relay and part#735 is overload:
Please do
accept the solution if the issue is resolved or else revert for further
assistance.
Thanks
Rylee
Not finding what you are looking for?