GE Monogram ZICS360NR Bottom Freezer Refrigerator - Answered Questions & Fixed issues
I have ice on the
ther is not a diagram of what you want / and in the parts brake down it is a drawing and does not show the drain . but you will find it in the back of freezer under the evap coil . I use hot water and a turkey baster and clear the ice and force hot water down the drain . it shoud work . mm hope this helps .. feed back pls .. and if it keeps freezing you can add a drain heater . too correct problem .
12/11/2010 8:38:23 AM •
GE Monogram...
•
Answered
on Dec 11, 2010
•
163 views
GE Monogram bottom freezer
ck the drain in the back of freezer . it may be pluged and when it goes into defrost cycle you get about a cup of water on the floor . if there ice on bottom of freezer then the drain is iced over . some models require a drain heater to prevent this . mm hope this helps ..
10/14/2010 6:35:52 AM •
GE Monogram...
•
Answered
on Oct 14, 2010
•
1,416 views
Refrigerator and freezer not cooling at proper
Hi,
Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing then checkout the last two tips.
If your refrigerator is running but warm, then...
Check out this tip that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...
Refrigerator
Condenser Coil Cleaning Refrigerator Repair
Refrigerator Troubleshooting Refrigerator Compressor
Refrigerator Compressor Start Capacitor and Start Relay
heatman101
rr
9/27/2010 3:17:08 AM •
GE Monogram...
•
Answered
on Sep 27, 2010
•
113 views
Water is leaking from somewhere,
Check the drain and put a thermometer in both ref and freezer
Ref should be 33 to 36
freezer 0 to 15
If it won't stay in this range replace the cold control
Different ranges cause water buildup.
9/17/2010 4:14:44 PM •
GE Monogram...
•
Answered
on Sep 17, 2010
•
156 views
Freezer turns off after 5 minutes then turns back
. Cut everything off for a few minutes then turn it back on and listen for a click from the compressor relay as the compressor tries to start.
Is the compressor motor running.If no check starter/overload relay. Place a probe on each terminal. The multitester should display a reading of zero ohms. If the overload protector does not pass this test, it should be replaced.
2/13/2010 8:05:16 PM •
GE Monogram...
•
Answered
on Feb 13, 2010
•
124 views
Water leaking. Mongram zic[s]360 (frig on top,
Have the fridge pulled out and check behind it. I had same model and it was leaking into my walls/floor and caused thousands of dollars in damage to my kitchen. BLACK MOLS Covered my walls/cabinets and made me sick. Please be very careful with this excess water coming from this model. GE should recall it but will not unless forced. Not Cool.
2/4/2015 2:39:17 PM •
GE Monogram...
•
Answered
on Feb 04, 2015
•
487 views
Ice build up bottom of freezer and water on floor GE Monogram
I had the same problem. The drain tube is located below the pan below the fins at the rear of your freezer. The drain tube has a trap (s-shaped curve) to prevent air flow out of the freezer. The problem is that water gets in this tube and freezes. I took the sheet metal cover off the back, got a turkey baster and flexible tube, and continuously flushed hot water (after the freezer had been turned off around an hour to thaw). Eventually the plug gave way.
7/16/2009 11:12:53 PM •
GE Monogram...
•
Answered
on Jul 16, 2009
•
3,673 views
Won't get cold
Make sure the temperature dial is set properly. The try to recharge the freon. If that doesn't work the compressor may be bad. Most of the time it's cheaper to replace the fridge than to replace the compressor.
5/6/2009 6:07:28 AM •
GE Monogram...
•
Answered
on May 06, 2009
•
199 views
Refrigerator and freezer are not cold
I just had service on mine and the repair guy said to donate it! He replaced the thermostate and the mother board and I am still having problems with it.
5/6/2009 4:54:54 AM •
GE Monogram...
•
Answered
on May 06, 2009
•
179 views
For a GE refrigerator model GFSF6KEX, how do you remove the ice tray? (Not the freezer drawer, just the tray.)
To remove the ice tray from your GE refrigerator model GFSF6KEX, follow these steps:
Empty the Ice: Before removing the ice tray, empty it of any ice cubes. This will make it easier to handle.
Locate the Ice Tray: The ice tray is typically located in the freezer compartment, usually near the ice dispenser or ice maker.
Grasp the Bottom Edge: Stand in front of the freezer and open the door. Grasp the bottom edge of the ice tray on the sides. Be cautious not to place your fingers near the opening at the bottom front part of the bucket where the crusher blades are located.
Lift Up the Front: Lift up on the front of the ice tray so that it clears the stops on the ice bucket rail.
Pull the Tray Forward: Pull the ice tray forward and out of the freezer compartment.
Reinstalling the Tray: To reinstall the ice tray, follow these steps:
Line up the flange pieces on the sides of the tray with the channels in the ice bucket rails.
As you push the ice tray all the way back, lift the front of the tray so that it clears the stops on the front of the ice bucket rails.
Verify that the tray is properly inserted by pulling it forward. It should hit the stops on the rail and not come out. If it does, push the tray further back.
Check for Misalignment: If you're unable to push the ice tray all the way back, it might be due to a misalignment between the back of the auger (located in the tray) and the prongs on the auger motor (mounted in the back freezer wall). To fix this:
Remove the ice tray.
Close the freezer door.
Press the dispenser for cubed or crushed ice; you should hear a snap.
Open the door again and reinstall the ice tray.
Remember to handle the ice tray carefully, especially if it's full of ice.
Not finding what you are looking for?