20 Most Recent
GE JGRP20 Gas Single Oven - Page 7 Questions & Answers
I can't get my GE range to self clean, I keep getting a F91 error whenever I try to clean.
Unfortunately, the F91 error indicates that the door lock is not functioning or the signal that the door is locked didn't get to the control unit. The range will not begin the self-clean cycle if there is a chance that you could open the oven door when the oven is dangerously hot.
First try cycling the power by unplugging the range (or turning off the circuit breaker). Next check if the lock has engaged. If the lock doesn't engage, check if the mechanism is bent or binding. Next check the wiring to see there is damage that will prevent the communication between the control board or the door lock. Check for corrosion at the wiring harness connections.
If the error happened after doing a self-clean, I'd suspect the door lock hadn't released. That can be related to a damaged over-temperature sensor or the lock itself. If the range has been self-cleaned before, it's possible that the lock was broken after forcing the door to open after that self-clean cycle.
You may need to replace the lock, the wiring or the control board. Please add a comment with the model of your range for a parts diagram. If your range is under warranty, contact GE.
I hope this helps.
Cindy Wells
6/26/2018 11:40:57 PM •
GE Ovens
•
Answered
on Jun 26, 2018
How do I set the clock on my ge profile wall oven?
Push the clock button until the colon between the hours and minutes starts to flash. Use the up and down arrow buttons to set the time then push the clock button once again to make the colon symbol go solid.
5/27/2018 3:54:54 PM •
GE Ovens
•
Answered
on May 27, 2018
Not finding what you are looking for?