Top 20 Kenwood KM800 Major Classic Stand Mixer Questions & Answers

I'm not 100% sure exactly what you're looking for but these folks have all sorts of parts lids/covers. https://www.espares.co.uk/browse/at1096ma435/blenders---mixers---juicers/small-appliances/kenwood hope this helps you. Cheers

Welcome to Boelter MilwaukeeRestaurant Equipment Repair Service JUST GOOGLE FOOD SERVICE REPAIR FOR MILWAUKEE AND YOU WILL GET SEVERAL DOZEN SERVICES. GOOD LUCK

I need service manual for kenwood KMM770

In my case, capacitor C1: 470nF (on the circuit board) proved to be the cause. It measured only half its normal value. It's part of a voltage divider used in place of a transformer. Replacing it solved the problem. Came already across the same problem in another circuit.

how to remove the shaft,1/2 sheered into the hub.how can i remove it@

Hi I am try to find cake wicker model qf3473

Hi Emma,Not going to be much help here to be honest. We have the KM020 and this is the only problem we have had with heavy machine use in 4 years - and a minor issue at that.This place is good for spare parts http://www.buyspares.co.uk/ If you're in the UK, you can call this number 02392 392 333 and give them your post code, they'll let you know who the local service agent is.All the best,

Force it out carefully. One person wrap tea towel over hook and turn forcefully, anticlockwise. Secnd person use a long handle screwdriver to hold the Kenwood still - wedge between the housing where the hook inserts. Hold Kenwood still whilst twisting the hook. When it comes apart, clean 'hole' and hook shaft thoroughly with WD40 / oil. Might need new hook if too damaged. Ours is ok seemingly.

Hello

try this website to get the part you are requesting www.spares2go.co.uk

Send me your email address and i will send you some info on how to repair it with modern components........... very easily done.

Send to bisley_bullet49 at hotmail dot com

it will be stripped gearing causing this to happen. The gears are made of nylon so upon getting stripped out you will not hear any noise from it to tell you that. If they were made of metal the noise would show when running

Go to http://www.kenwoodworld.com/uk/Customer-Service/Instruction-Books/ and click on "select category" and insert your model number

check the power cord possible damage and the motor resistance if ok. also the pcb board

Try Amazon
here
or if not in UK
here
I hope I have been of help but please do not hesitate to ask if you have any further questions.
I appreciate your vote if you appreciate my reply.

Mixer provides the facility to convert the power to another one.
In the mixer you will provided the key to convert 220 volt to 110 volt.
Drag that key to 110V.

take a belt and made your own home-made-belt, if you just want the machine not be shaken so much

hi its not necessarily the motor but could be some capacitors on the speed control unit ( the control knob is attached to it) spares are reasonable to buy .you can find a dealer from kenwood.co.uk website..

I have a Kenwood Chef A701A. I cannot find where to insert the mincer & grinder attachment.Can you help?

You can buy genuine spare parts for most models of kenwood chef at http://www.4kenwood.co.uk/cgi-bin/home.pl?gclid=CNWP5ffou60CFUUPfAodnj9lAg

Hi

You can see the local repair tech.s in and around your area by visiting the below link--

Appliance repair Link

Enter your zip code in the link and it will show you the local tech.s details. Hope this helps... Please post back with your zip code if you need more information.
Daniel