20 Most Recent HP Photosmart C7250 All-In-One Thermal Printer - Page 6 Questions & Answers

Sounds more like an out of paper response rather than a jamb. Make sure the pickup roller can actually catch the paper. Use a polymit to roughen the rollers slightly in the slot where the paper is contained. If you take the paper out and look down the slide that holds the paper you will see two or sometimes 3 rollers They can become shiny and fail to grab the paper. Make sure you use proper printing paper and not photocopy paper as this is the stuff that has resinous coating that causes rollers to become shiny.

To also ensure that there is not a tiny piece of paper covering the detection eye for paper jamb use a piece of stiff card and run it through the paper path with a little assistance from you pushing it while the roller turns. This will often remove any tiny bits of paper or waxy substance from the eye.

Please rate my help++++Thyanks for using FIXYA

lolz all u half to do is clean the yo part where u scan stuff
if it sousnt work then u dont have the right ink

I have to ask this question of you, just to make sure this is not an issue. Are you using a factory new ink or toner cartridge?
Please consider the following:
If you are using a refilled (the absolute worst possible choice) or third party cartridges (2nd. Worst possible choice) that may well be your problem. Most manufacturers build logic into their products to prevent the use of “Other Equipment Manufactured” cartridges as well as re-filled cartridges.
They do this to prevent problems from contaminated inks or toner causing problems with print quality or damaging the physical printhead or photo conductors.
If you are using factory new ink or toner cartridges, then please call the manufacturer’s Technical Support for assistance with the warranty on the cartridges
Don

Hi there

You need a program that you can use on your PC with this program you scan it to your PC and then print it out, ok you need a program like art or photo or paint or some thing like this that have a scan in it.

Read more below.
The best program to put on your Pc is what I use and it is Free you, it is called PagePluse SE, you should try it you can do all sort of things with it but there no scan on it, just scan your photos to the your pc with another program witch has scan on it and put them in the SE program and you can do any size you wont and after adding text to it or backgrounds you can send it to the printer and print, an other program I use for scanning from the printer to the PC is called PainShop Pro 7 witch is a old program there newer ones out now but I am happy just using the old one it does the trick.

The Free version is Called PagePluse SE you not need the version 9.

Ok here the link to download the PagePluse SE program and it not a free trial it a free, there is one you can Buy but this is all you need download the free one it just as good.

Click Link = http://www.freeserifsoftware.com/software/pageplus/index.asp

All I ask is please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

Thermal printer? Normally a thermal printer doesn't have cartridges.

Anyway, my opinion is you should not refill ink cartridges. I have a basement full of printers with dead print heads due to third party ink being used or third party cartridges being used in a wide assortment of printers including a HP Photosmart.

Don't run the risk to save a couple bucks, please.

Thanks for you interest in FixYa.com

Hi,

Make a wireless connection between an HP all-in-one with built-in wireless networking capability and a functional wireless network with an access point (router) that is SecureEZSetup enabled.

Connecting the unit to the computer

1. Activate SecureEzSetup on the access point (router). Usually this is accomplished by pressing a button on the access point. Refer to the router or access point documentation for specific instructions.
2. Press the Setup button on the all-in-one.
3. Press the arrow buttons until Network displays and then press OK . The Network menu displays.
4. Press the arrow buttons until Wireless Setup Wizard displays and then press OK .
5. Follow the instructions in the Wireless Setup Wizard.
6. After the all-in-one connects to the network, install the product software on the computer.

Regards,
Rizwan

Were you able to install the correct driver for your OS? Usually the scanner application can be found in the list of Programs >> HP Photosmar C7250. If what you are referring to is the icon on your System Tray (lower right corner), you can always add an icon there by right clicking the blank space in your system tray and choose properties. On the taskbar tab, click on Customize, look for the icon for your scanner, click for the behavior and from the drop down button, choose "Always show".

Try to scan also by pressing the scan button in your printer and press start to initiate a scan.

if you are asking about hard reset it is basically applied to all the devices
please follow the following steps:-
1.turn on the printer
2.disconnect the power cable from the back of the printer
3.after 20-30 seconds reconnect the power cable back to the printer
this is the process of a hard reset
thank you
HAMID

If you follow the instructions in this video, it'll solve your problem or tell you that your printer is broken.

I have the same problem

If the ADF (auto document feeder) is not picking up the paper, you could try the following support document: (Copy and paste the following link into the location bar of your browser)

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01081903&tmp_task=solveCategory&lc=en&dlc=en&cc=us&product=3382185&lang=en

Are you using a factory new ink cartridge?
Please consider the following:
If you are using a refilled or third party cartridge that may well be your problem. Most manufacturers build logic into their products to prevent the use of “Other Equipment Manufactured” cartridges as well as re-filled cartridges.
They do this to prevent problems from contaminated inks causing problems with print quality or damaging the physical printhead.
If you are using factory new cartridges, then please call the manufacturers Technical Support for assistance with the warranty on the cartridges
Don

This happend to me!

You may have fed a wet sheet through the feeder. This will pick up ink and transfer it to the glass.

Lift the main lid over the glass and then BOTH covers on the feeder. There is a glass area to the far left.

Jim

Clean it and you should be good to go.

the sensor that tells the printer if there is paper is bad. I have heard, havent verified, that HP printer sensors dont work well with paper other than HP paper.

1. Click on starts
2. Click on Printers and Faxes
3. Cancel any pending prints
4. Try printing again
   

Scan a BLANK sheet of paper.
if you have that black strip it means there sre two possibilities:
>> the scanner glass is not screen
OR
>> the scanner is faulty.

Clean the glass properly using a moist lint free cloth.(do not use alcohol)
if the issue still persists

The only option that you have is to get the printer replaced.
If your printer is still under warranty(i.e if its still not an year old) you can get a free replacement from HP.
wherein they will send you a new printer absolutely FREE OF COST
if its not in warranty then you can opt for the UPGRADE option that HP has.
You can send them this faulty printer and get a LATEST PRINTER at a huge discount..
here's the number to call
1800-474-6836