20 Most Recent Emerson LC320EM9 32 in. LCD HDTV - Page 5 Questions & Answers

Check the remote for its infrared emission. If found OK, check and replace the infrared sensor inside the TV. If you wish to get some details, http://electronicshelponline.blogspot.com/Pull up older posts.

If you wish to get these details, you have to download the repair manual to this set. The disassamebly section of it will have details. If you wish to get some details, http://electronicshelponline.blogspot.com/ Pull up older posts.

1- Have you tried a different input cable?
2- maybe try using the set top box tuner?
3- check the input setting on TV?
Good luck

you need to change the 'zoom' on the tv by the remote. Normal mode frames the 4:3 video to the 16:9 picture area by displaying it in its original aspect ratio, with vertical gray or black bars on both sides of the screen. The disadvantage of this method is the fact that the image is small by virtue of not using the entire width of the screen. This is also known as the 4:3 mode. Full mode Full mode horizontally stretches the 4:3 video evenly across the entire width of the screen. This is the proper mode to display anamorphic video. If used for standard aspect ratio video, everything on the screen will appear wider than normal. Contrast this with anamorphic video displayed without processing on a 4:3 display, in which people on the screen will appear taller than normal. This is also known as the 16:9 mode. Zoom mode Zoom mode evenly stretches the picture both horizontally and vertically, until the picture fills the entire width of the screen. This crops out the top and bottom of the picture. This mode is used for letterboxed and open matte video. 14:9 mode Main article: 14:9 In 14:9 mode, the picture is magnified more than in Normal mode, but less than in Zoom mode, while retaining the original aspect ratio. Wide Zoom mode Wide Zoom mode, also called Just mode, Horizon, or Smart Stretch, progressively stretches the picture horizontally, less in the middle and more on the edges. This allows normal aspect ratio video to be displayed across the entire width of the screen, with minimal cropping, and with much less of the unpleasing visual stretching effect of Full mode.

sounds like its zoomed in, have you tried playing with the zoom button?

Try another component video cable. It sounds like the red signal isn't getting to the TV.

You will have to find what the native resolution is on your monitor. Then you will have to go into your computer control panel under display and change your resolution to match the monitor.

The SMPS transformer you are searching for is very difficult to get. Just try to get its power board and replace it.

check if your pc resolution or display needs to be changed.

Two blinks of stand by light indicates a fault to its back-light system. If you wish to get more details, check this link. http://electronicshelponline.blogspot.com/ Selecting the view option, either to Mosaic / Flip card, can be selected by the drop-down list, by the top left of the display window, will make surf easy. You can also do a search, by type in the brand name / model number / IC used, in the search box at the top right of the display window. Blinking codes to many brand TVs are given.

Make sure you have the input set correctly in the set up mode.

If you done't have a separate audio input, you can't. Some TV's that can be used for monitors have a separate audio jack just for that purpose. If it doesn't, then you will have to get a separare set of speakers and use them or a headset direct to the computer.

I would recommend powering off the dvd player and unplugging it. If the screen persists then the issue might be with the tv or the screen itself. Could be a simple setting. If that doesn't work, message me back with more details and I will see what I can do for you.

T'Con board fault.

usually FAT32 works with most equipment. its ok for 4gb movie files. 4gb per movie or under.