20 Most Recent
Dell Latitude E6400 Notebook - Page 9 Questions & Answers
Why is my Cursor not moving dell latitude
- Click Start.
- Click Control Panel.
- Using the drop-down menu next to View by: in the upper-right corner, select Large Icons.
- Click Mouse.
- Click the Dell Touchpad or Device Settings tab.
- When the Dell Touchpad tab option shows.
- Click on the picture of the touchpad.
- Click Gestures Settings (depending on your computer there may not be a gestures option).
- After changing the options click OK.
- When the Device Settings tab option shows.
- Click the < + > next to open the options you want to change.
- After changing the options click OK.
How do i changr my internet pass code
Hi,
I will be glad to help you. Please provide more information about the issue like are we talking about a wireless password or an internet password. Also send me a screenshot of the password prompt page.
Note: As this is a public forum please try to block all your personal information and then send it.
Thanks and Regards.
Kiran Kumar.
#iworkfordell.
How do i reset set my dell laptop to factory settings without an administravive password
The only way is to use the re installation disk that came with the laptop when you bought it. The disk should say something like "Reinstallation" or "Restore". You will loose all content.
Similar to the picture below. May have different wording and color.
If you are not computer literate, I would recommend getting help from someone that has experience.
How to make the picture from laptop to projector the right size.
I would suggest it's probably a screen resolution an older laptop VGA output was probably 800x600. The projector will also have a recommended and maximum resolution. The newer laptop will have a much higher resolution. You will need to adjust the laptop's video resolution to the optimum projector resolution
How do I find the calibration panel which has vanished from the control panel settings
Hi,
Request you to try following the below steps which might help:
(1)Click start.
(2)Type services.msc in the search box and select the same.
(3)The services screen appears and detect Human Interface Device.
(4)Right click on it, select properties, select start up type as automatic and then start the service.
(5)Now restart the computer. Now check if calibration panel gets detected.
Thanks and Regards.
Kiran Kumar.
#iworkfordell.
Would no battery charger cause wifi to disable
Your power saving settings might be configured to disable WiFi if the laptop is not plugged in
.
The power settings will be in the screens saver section, and in the control panel under Power Options (or just search for Power Options).
Look at the settings for your power plan and tell it not to disable WiFi when not plugged in.
Not finding what you are looking for?