Top 20 Panasonic KX-TA824PK Phone Questions & Answers

smell the moter if it smells like burnt electrical it may be fried but check the wiring real good before u give up alot of the time the wires start to melt before the moter

First assing the flexible ringing day, night, lunch in programs 408 to 410, the assign the delay ringing for the extensions you want in 411 to 413.

You need to download a manual, is the system allready install with the extensions and the trunk lines?

Have to set program 619 for each extension .

You can program call waiting tone, pick up the handset and dial 7311# to each extension so whenever a second calls comes in you will be recieving a tone.

hrgr

Lines are assigned in program 400. Normally, they are assigned by default so someone had to work very hard to unnasign them even though you didn't have the hardware.

You will need to put the card inservice (INS) and permit the extensions to call out.

thank you for calling calibre please dial the extension number or wait for the operator thank you

First set your DSS in program 003, then pair it with your phone in program 004, then check program 005 to assigng one touch transfer.

If your Panasonic phone device runs on 110v then to connect it to 220/240v mains supply you need to purchasr a step down transformer that converts 240v to 110v.Make sure the step down transformer has a wattage equal to or greater than the rating stated on the Panasonic phone device.

You need a step-up transformer (110V-220V)

You could, but it would be a whole lot easier to press PROGRAM the one-touch button on the right and dial 330 STORE.

Takes less time :-)

Carl

By default, a TA-824 seizes outside lines from high to low. You can't change that order, but you can dial the 8x code to get each line. As an alternative, in program 400, you disable the lines that don't work, but you'll still select the highest line assigned to the single line port when you dial 9. I don't know why your PT is different, but when I dial 9 on the intercom of my PT, I also select the top line. Carl

What info are you trying to download? My TA-824 came with a Maintenance console that runs under Windows XP or highter. You plug the phone system in, turn on the power, and plug the USB cable into the system. You need to install the MC first, because it will put USB drivers on your desktop that the phone system needs to find when the cable is plugged in. After it finds it, you run the MC software and it will connect to your TA system. Now you can Get program from the PBX and put it in a file on your PC, or upload a program from your PC to the TA system.Carl

Been a long time....try 729.

Carl

It initializes in 808. Try looking in the installation manual for the complete programming references.

Carl

Get your manual out and review DISA. A single port is included in the U.S. version of the system. It's the best way to make this work, because a TA-824 doesn't have ring groups except from the DISA card.

Carl

It's a DISA (Direct Inward System Access) card and you don't. All you have to do is just turn it off in software. In C.O. programs 414-416 or 3.1 in the Maintenance Console, you make sure that no lines are pointed to DISA and probably set to Normal and the system will ring normally.

Carl