20 Most Recent
Panasonic KX-T7730 Corded Phone Questions & Answers
Hi There,
Press down the vol it will show the miss call
12/19/2022 7:34:16 PM •
Panasonic...
•
Answered
on Dec 19, 2022
Hi everyone, I have got a panasonic KX TES824
First the button clear position
anfter press hold reset 20sec
it will reset
after turn off PABX
move the button to open position
and strat the PABX
Please let me know this is helpful
4/7/2022 4:45:44 AM •
Panasonic...
•
Answered
on Apr 07, 2022
NO DIAL TONE
Since an Analog Pana phone uses two pairs, swap phones completely with someone else. If the phone you had works somewhere else and the phone you borrowed does not, it's a wiring issue.
The phones light up because the data to make the display and lights travel on the second (black/yellor or orange) pairs of the jack (pins 2&5). The voice is on the first (pins 3&4) pair.
If the phone is bad, it's bad, but I'm guessing your missing a wire on the red or green lead of the phone jack, either from a bad base cord, or a bad jack.
Carl
8/29/2021 1:14:57 AM •
Panasonic...
•
Answered
on Aug 29, 2021
Programing outside (CO) line button
press program button then press the flexible where you want program the CO line then press 0, here u can select which CO line need to be program.
Ali
3/4/2021 3:31:52 AM •
Panasonic...
•
Answered
on Mar 04, 2021
Normally all thes phone
you have to do that in the pabx setting where by you set all out going calls to be calling direct but all incoming calls to be calling to the switchboard first so change the call restriction feature
9/21/2019 9:54:06 AM •
Panasonic...
•
Answered
on Sep 21, 2019
To enable caller ID phone tes824 through 7730
Hi
I am using Caller ID software and I want to configure PBX to send the log call to our program when an incoming call, then when I answer the call and another after the end call, is there a way to define the PBX to do that
note : PBX now send call log only after the end call.
9/19/2019 9:43:39 AM •
Panasonic...
•
Answered
on Sep 19, 2019
Call Customer Service 1-8O5-465-751O To Fix Issue
Outside Line Button.
I doubt you would be looking to "delete" the number. Instead you need to program that button to be a line button again and that will in effect delete the quick-dial you programmed. I'm not sure which phone system you have your phone connected to (you could have one of several different Panasonic systems) but programming the button for a line should be somewhat similar to programming it for speed-dial.
Does the manual you have cover any other programming options for buttons?
It's a long shot but some systems I am familiar with you can just push the same button again instead of the number. So for example if this was the line3 button, program similarly as you did before but at the step where you dialed the number, just press the line3 button.
If you're still stuck, let me know which Panasonic phone systm you have so I can look up more detail (the system is not a phone)
8/26/2019 10:52:59 AM •
Panasonic...
•
Answered
on Aug 26, 2019
Not finding what you are looking for?