20 Most Recent Casablanca Fan 3245T Ceiling - Page 2 Questions & Answers

What happens when you enter demonstration program?

If you haven't the demo program yet, you may run the demo using these steps:

-Turn off the unit for about 3 seconds.
-turn the power back on then quickly press the following button in exact sequence: FAN, LIGHT, FAN, LIGHT, FAN

A multi-tone signal will verify the test program and will operate/test the functions of your fan. Turn off the fan to stop the test.

Let me know the result. Thanks.

The controler board has gone out due to either a power surge, overheating or too much wattage in the lamps. There are two types of of controlers and both are subject to this kind of failure. Here's a troubleshooting link
http://www.lampdepot.com/service/intellitouch.htm

make a cuavature digram and air flow rate in the terms of rms,and his cmf .when fan of diameter is 120m .

My fan operates the same way. To reverse it, turn it on a low speed. Then, turn it off and on, then off and on again, quickly. You should hear a series of beeps, and the blades will slow down and then reverse. You may have to play a bit with the timing of the off/on/off/on sequence to get it right but you should be able to get it fairly easily.

Hello,
Use the fan regulator to adjust the speed of the fan, and if it does not adjust the speed, then you have to replace the fan regulator.
Good luck...

Replace the switch. When Power Company electricity goes out and comes on by itself, it often "Surges" frying small electronic components. This is what happened. No biggie...happens all the time. Be sure to turn off power to the switch in your breaker box first.

obtained to new ones

It could be either, but here's something easy to check first. Look inside the remote. You should see a small rectangle with several (usually 4-6) extremely tiny switches on it (called DIP switches) The receiver inside the fan shroud has one as well. The switches must be in the same pattern to work. It doesn't really matter what the pattern is, as long as it is the same. (that is for setting the frequency to prevent interference if there are several near each other)

wire connect is disorder problem check the wire then try to change the light

Thank you, but I already found a web site that sells the conversion kit to update the fan.
I understand that the original parts are no longer made and it is recommended to convert.
Thank you!

Push and hold the button.

im not familiar with this model but you will need a pole to give the blades clearance from the celing and electricl conections uyou sometimes get two poles but as long as you have plenty clearnce one should be ok

itake it the light is still working if it is check the wireing from the pull switch to motor unless you have a neon live tester or volt meter thers nothing else you can check

it is the flywheel. I ordered one directly from the Casablanca web site, took the fan down and find the parts are pressed together. Looks like it needs some heavy tools or a jig of some kind. Any suggestions?