20 Most Recent RTO Bock Water Heaters 32E 32 gal 104,000 3/4" 3/4" 0.75 - Page 8 Questions & Answers

Reset power to the product:

There may be a problem with the Water Level, Water Level Sensor, or the associated wiring.

• Power unit down by turning off the circuit breaker(s) for one (1) minute.
• Power unit up by turning on the circuit breaker(s).
• Monitor the oven for one (1) minute to ensure the error code does not display again.
• Verify oven operation.

I have a Takagi T-KJr2-IN-NG blinking "99" The heater isn't doing anything when hot water is turned on. I checked the breaker. I checked the intake/exhaust is all clear. It is installed in a closet although there is no door, just a cased opening... so it seems ventilation should be fine. We built this house about 8 months ago and the water heater has been working well during that time. There was a lot of dust that probably settled during the transition from building to living in it although it looks clean within the WH box. Grateful for any help solving this.

I DON'T KNOW. PLEASE TRY TO INCREASE THE TEMPERATURE CONTROL, IF ANY.

Yes it can be converted, however you cannot buy orifice, will require a license. https://www.rinnai.us/faq/tankless-water-heater/can-a-rinnai-tankless-water-heater-be-converted-to-a-different-gas-type

We are a local plumbing and drain service that sees these types of failures on these types of water heaters all the time. Call us today for your free in home Estimate. We are affordable, & offer same day services. (Let us know where you found us for your Discounts)Alpha Omega Discount Plumbing & Drain Services 661-836-8813 Bakersfield, 661889-2625 after hoursLicensed #945568 BBB Accredited

Replace the GFI plug end.

HOT TOASTER

Customer ser

Normally for adding air to the bladder. Only add air if your pressure of low. Look at your paperwork of on the unit to see what it should be. The bladder pushes water out of the tank.

As a reminder always be careful working with gas appliances. https://www.manualslib.com/manual/1075413/Ideal-Logic-Combi-35.html?page=33#manual

www.richmondwaterheaters.com/Contact-Richmond-Water-Heaters

Have you cleaned the air intake screen located below combustion chamber? http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#intellivent http://www.thetankatwaterheaterrescue.com/forums/forum3/ Gene If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Had a similar problem with my boiler. Turned out the blower was bad, was running too fast, and the system was shutting down with an error message. Was expensive to replace.

http://www.fixya.com/support/t25787924-bypass_energy_smart_panel_whirlpool

Request from manufacturer

https://www.youtube.com/watch?v=Uk_htzQKHMQ

Clean the flame sensor

This is not a DIY you need to call for service. this is user non repairable and there is no magic mouse milk 62 i s Maximum Number of Retries Detected 63 is Maximum Number of Ignition Recycles Detected

Google it!

I had the same problem. There's another clear rubber pipe underneath, that runs from the front right to a pump in the middle. I had to pull it off and dry it with a hairdryer before mine would light properly. Blast into the hole the pipe came off too to dry the sensor if there is one.