20 Most Recent
Tippmann 98 Custom Act Paintball Gun - Page 4 Questions & Answers
Paintballs fall out of tippmann
Go to ebay and buy a new ball detent for the 98 they are cheap and well worth it because how many times have you got shot for double balling :)
I attempted to put a car stock on my Tippmann 98
Check the O rings on the big metal striker, make sure that you have the spring on the back (where the stock would have went) in the right hole on the back plate. Make sure that your velocity is set to a reasonable level.
Squeeze trigger once and
if there is a 9 volt battery in the handle, there should be 3 to 5 small dip switchesright by the battery, your set on 3 shot burst, unhook the gas, turn all switches off, and test it, there is also a full auto setting, try different combinations untill you get single shot
More then one ball coming out
Your "ball detent" has worn out. This is a little rubber nipple inside the breech of your gun (where the balls go into the gun from your hopper) that has torn. This is a normal wear and tear item and will cost you only a few dollars to repair. You have to buy this part from your local paintball pro shop they will have it.
How to change the volocity of the tippmann 98
I have the exact same gun. Looking at the gun, barrel facing left. You'll see the word Tippmann. Just below and slightly right of the end of that word you will see a allen head screw. Using and allen wrench turn that screw. If you wish to raise the velocity, tighten the screw. If you wish to slow the balls down, loosen the screw (bring it out, but not too far.) The faster the paint balls go though, they have a tendency to burst (but not usually) or the big thing with mine, is they get more back spin, and they travel UP, making them also go further. If they go to slow, they are pretty inaccurate. I find my optimum performance, when the allen screw is flush with the plastic on the outside of the weapon. Hope this helps!
\\Seth\\
Wont stay cocked
If you ran out of air, it won't stay cocked.
OR
The sear may have been displaced. That would require a disassemble. It is not that difficult, just do it on a white pillowcase and be sure not to let any springs fly all over the place.
Velocity stuck at 330 fps
No O-rings are used to change volocity on Tippmann Markers. The velocity screw is on the left side and is turned clockwise to decrease and CCW to increase velocity. Typically if you turn the screw in till it stops then turn it back 2 turns the gun will shoot about 280FPS.
Hi we need a manual
Hi Linda, i have the same 1983 Travelaire motorhome Econoline F-350 26ft and are in search of the Shop/owners manual ... Do you know where to find one ?
I am located in BC Canada
Reg 250-379-2971
[email protected] if you can contact me ?
How can I maintain my pool table at top condition?
In
order to maintain the condition of your table and prolong its lifetime you
should avoid eating above the table, putting drinks of ash trends on the sides
of the table, and generally try not to harm the cloth with the cue. In addition
you can clean and vacuum the table from the outside once a month, this Is what
I'm doing to my table.
What is the price range of a quality foosball table?
Good quality and long-lasting table start at
about $600. In this case, like in many others, the more you pay, the better
quality you will get. Make sure that you're buying a known brand and compare
prices first, before you buy. It is also recommended to read some reviews about
a table or tables that you like.
Not finding what you are looking for?